You did a Good Job no matter what anyone said, is a complete showing the process. Thanx again
@dunlapmichaell
6 жыл бұрын
The most difficult part I had was getting the center pin lined up.....a bear!
@paulwallace9644
Жыл бұрын
great job thank you very helpful
@busabobsgarage9876
Жыл бұрын
Glad it helped, thanks!
@charlesphile9232
2 жыл бұрын
Video could have been a bit better if you actually showed the work being done to this jeep vs showing after each item or part after completion
@robg3367
2 жыл бұрын
Great video. Thanks
@bowhunter2712
2 жыл бұрын
Thanks for the video it helped a lot with me understanding how to get this done. Did you ever find out if the pad end on the spring went to the front or the back?
@busabobsgarage9876
2 жыл бұрын
Sorry, it's been a while since I did this and the Jeep is long gone. Good luck with your project.
@MrArcee52
Жыл бұрын
Thanks for the video. I'm about to install a 2.5 Pro Comp. Were you able to reuse the stock sway bar link?
@busabobsgarage9876
Жыл бұрын
Hi There, The Jeep is long gone, but I think I reused them. If in doubt, I just saw a set of adjustable links on ebay for $40. Good luck on the project.
@williamthompson969
4 жыл бұрын
Breath man
@jsmeswagner6104
5 жыл бұрын
My leaf springs are way too short
@wulfadventuresllc5845
5 жыл бұрын
Me too gotta be compressed?
@williamthompson969
5 жыл бұрын
Stroke worthy
@jimbob2422
5 жыл бұрын
Please dont use screws to install your leafsprings
Пікірлер: 19