Thanks for watching. I am glad it helped. I appreciate you taking the time to comment.
@Aghosthouseproductions
2 ай бұрын
What company make is your hood? Thanks
@DocsBoost
2 ай бұрын
Mamba
@DocsBoost
2 ай бұрын
BMC Extreme Customs: Ford Mustang GT500 Black Mamba Hood 2010-2014 www.bmcextremecustoms.net/20fomugtshsu.html. I bought a relocation kit for the windshield washers along with the hood.
@paulhladysh3783
Жыл бұрын
Nice pins
@Twobarpsi
Жыл бұрын
You always have THE BEST GT500 Tech on KZitem!!
@DocsBoost
Жыл бұрын
Thanks, sir.
@jasonmorin7976
Жыл бұрын
Very good. The metal is super thin in that area, you must becareful
@DocsBoost
Жыл бұрын
For sure. Be careful. If you go too big, the insert cannot grab and hold. If that happens, you need to take a large washer and with a step bit, open the hole to 3/4" and make sure the hole is a tight fit on the insert. Then carefully spot weld that washer over the bumper hole that is too big. That works because I had to do it on the passenger side. It works great. So just be careful taking those holes out to 3/4".
@RonVik7
6 ай бұрын
How to screw on the bolts onto shelby rings ???
@DocsBoost
6 ай бұрын
The whole operation of getting the "compression" or "rivet" like inserts installed is trickier than you may think. If you get the hole just a little too big, the insert fails.
@RonVik7
6 ай бұрын
@DocsBoost that's what I did ;( the hole os too big. Now I am gonna have to use screws to install them. Do you spray drilled holes with anything to prevent rusting ?
@RonVik7
6 ай бұрын
@@DocsBoost also does the hole have to be perfectly round?
@DocsBoost
6 ай бұрын
For best results get it round as possible and make it a tight fit. You will be glad you spent the time getting it right. I used a drill bit and it was not the best choice come to find out.
@DocsBoost
6 ай бұрын
Okay, I also ended up with the hole too big and I had to buy another install kit. Before I used the second kit, I went to the hardware store and bought myself a large flat washer with a diameter just a bit greater than the beauty ring that comes in the install kit. I used a step drill to make the hole a tight fit on the insert. I mean it was a very tight fit. Then I tack-welded the washer in position and everything worked perfectly.
@stephenbaker2056
5 ай бұрын
Nice I wish my install kit was the same thread as the hood pin because it’s not.
@DocsBoost
5 ай бұрын
What??? That does seem to make sense. Maybe Shelby sent you the wrong kit.
@stephenbaker2056
5 ай бұрын
@@DocsBoost the installation kit is discontinued now called today I’m getting a refund for install kit.
@DocsBoost
5 ай бұрын
I better hide the one I have. LOL
@DocsBoost
5 ай бұрын
Glad to hear you are getting a refund.
@stephenbaker2056
5 ай бұрын
I already installed mine and came up with a possible solution. Is there any way you can measure how far your pin sticks up past the beauty ring?
Пікірлер: 28