You need several coats of poly on both sides of the MDF if you don't want it to move from humidity changes. Probably a good idea for the plywood to be finished as well.
@condor5635
Жыл бұрын
Just a thought but I don’t think all those pocket screws were necessary. The end result with a good glue up with that huge wood matrix would’ve ended in the same results.
@silvanuswood956
Жыл бұрын
#3 Carpenters Tipp ☝
@raynavarrete7898
Жыл бұрын
Just what I need, right now! I've been struggling to straighten a tick board to use as a base for other boards, but it is so hard to get it perfectly flat!
@joemedeiros8433
Well built, but WOW, bro, completely unnecessary. That torsion box reduces the planer's cut capacity by half. My 3/4" melamine sled gives me a dead-flat surface every time.
@Chvdxii
Жыл бұрын
Could you use a 3/4 piece of melamine, or do you need the added height for some reason? Genuinely curious no hate!
@orangeduc3129
Good job
@joey.g
Жыл бұрын
So as I'm understanding at the rollers of the planer don't allow the board to live flat so you have to accommodate when not using a jointer
@roberttill3787
I havent seen anyone advise that it is stored on a flat surface to stop potential warping.
@haltz
Жыл бұрын
people sure do love pocket holes
@brandon152lee
Жыл бұрын
Very cool!
@equinoxproject2284
The piece isn’t flat because the sled is flat…it’s flat because it was held in a static position while going through the planer. Granted the flatter the sled the less material you will need to remove from the stock to get the stock nice and flat.
@satishpathy
Жыл бұрын
What are the dimensions of your torsion box? Assume the width is around 13”, more interested in knowing the length dimension. Thank you.
@joey.g
Жыл бұрын
Can you just lower down the plainer so that it pushes on the wood what is the purpose of adding the sticker material
@wizardmaster6639
why - I keep my wood straight and right and never need to send it to the chopper - Chomper yes, chopper no
@TheTsunamijuan
Жыл бұрын
I hope its relatively dry in your shop. Cause if you have high humidity. That MDF is likely to swell inconsistently over time. I won't mention how i know this :D
@georgevillanueva6926
Жыл бұрын
😅so.. had to watch a second time because I didn’t hear u mention the slight twist in that board 😂man that threw me for a loop..the shim messed me up
Пікірлер: 50