Just put a screwdriver through the output drive cup like you did in the ball diff build video. Instead of popping off your tie rod end and removing your tire and hold the spur gear with the same hand...........awesome tips I learned allot.
@markthompson6196
12 жыл бұрын
Excellant ! informative and very proffessional. Good job!..........You should do radio!
@TheRacer53
12 жыл бұрын
@cruzin33 Anytime...Glad it helped you out...
@daveferrell3889
10 жыл бұрын
@ woepiedoepie1 Sounds like you need to shim your diff more. The most common set up for the B44.1 is to run 6 shims on the Gear side and 4 shims on the long (non gear) side. This should help you from stripping or ruining gears. Cheers!
@jdeadman
12 жыл бұрын
Just a tip to make it easier on the ball cups and from having to put the tire on all the time use a hex driver in the outdrive slots to hold the right side from moving. and you can adjust really easily. Cheers
@DIECASTCOLLECTORIN717
12 жыл бұрын
My mip diff doesnt spin in opposite directions.When I turn the right wheel forward the left goes forward aswell.If I hold one tire it makes a gear grinding noise.
@TheRacer53
13 жыл бұрын
@woepiedoepie1 I'm afraid I have very little expirience with 4wd buggies...Might I direct you to rctech.net as an awsome resource for any questions I cannot answer...
Пікірлер: 8