I watch a LOT of instructional videos. You are doing what every instructional video should be. Very good, important details outlined. I wish every how- to video was this clear and concise. Great video man. You even covered a couple points no other video is covering for me.
@cameronmardis
7 жыл бұрын
Awesome video and congrats on the triple win in Nationals. 👍🏼
@savantelite
3 жыл бұрын
I had no idea about barking. Awesome video.
@sc10rs
7 жыл бұрын
Great vid!!!
@quadflopper1012
6 жыл бұрын
what am i missing, a ball diff is just a form of a ball bearing that's under pressure, you have metal diff balls that ride in holes in a gear, usually some variant of a polyamide, with a thin coat of lubricant against a metal diff ring, there's no brushes to that need seating or pads that need bedding, it's just metal on metal contact surfaces creating friction so what are you breaking in?
@eins2001
6 жыл бұрын
Quadflopper101 you want to start forming a slight groove in the diff rings for optimal contact. It's kinda like the races in ball bearings.
@Harddeckmyass
3 жыл бұрын
@@eins2001 I never knew that, thankyou 🙂
@jtr4405
3 жыл бұрын
@@eins2001 can i flip the metal ring over if I have incorrectly created a deep groove after the break in? Or do i need to replace the metal ring completely?
@Pops180
4 жыл бұрын
When breaking in a ball diff. What do you have your slipper set too? Tight? Loose? Does it matter at all?
@rasmuslange2041
2 жыл бұрын
I don't understand. What is he tightening? How can the hex screws be accessible while the diff is in the car?
@MrPageplayer
6 жыл бұрын
Ok, but what stiffness rod do you use when flipping under boat docks?
@turbined
6 жыл бұрын
MrPageplayer mh fast action hahaha
@00godlovesus
5 жыл бұрын
Thanks again;)
@royarsey5429
5 жыл бұрын
xray don't use pillow ball front end anymore?..i thought they were on 1/8 nitro
@wbhandy
2 жыл бұрын
“As loose as they go without barking” doesn’t make much sense to me. In that case why not just run a gear diff with super light oil?
@Powerpickle68
6 жыл бұрын
What do you mean by the diff "barking"?
@cameronhale4815
6 жыл бұрын
They will make a noise overpowered for the setting and slipping, sounds like a chirping or barking sound. If you’ve never heard it, good. You’ll know when it’s barking, will be pretty pronounced when you pin it on a start
@jtr4405
3 жыл бұрын
A video showing an example of what the buggy sounds like when it's barking vs not barking would be helpful for us beginners
Пікірлер: 18