If you are replacing your VW Vanagon Radius Arm Bushings there are a few things you should know that can make the job much easier. In this video I go through the proper procedures to replace the radius arm bushings. I found the Mueller-Kueps large wrench extender a must to break the radius arm free, as they are torqued to 133 ft/lbs. I replaced the factory steel sleeve as it was rusted and worn through. I cleaned up the radius rods and coated them with POR15 to help minimize future corrosion. The threads on the radius rods are M18x1.5mm, and I used a tap to repair the threads as they were quite rusty.
Mueller-Kueps large Wrench Extender
Amazon.com
amzn.to/3VdN7mw
Amazon.ca
amzn.to/3VdJxZj
KTOOL wrench extender
Amazon.com
amzn.to/3Uelubu
Amazon.ca
amzn.to/3OYopEt
As an Amazon affiliate I may earn a small commission on a qualifying purchase, this does not affect your price at all :) Please consider supporting the channel :)
#vanagon #suspensiontraining #suspensionparts #diy #automotiverepair
Негізгі бет How to Replace VW Vanagon Radius Arm or Radius Rod Bushings
No video
Пікірлер: 26