Check the connection first.
The receiver mounted is RadioLink 8-channel receiver R8FG, which comes with RC8X. There are many servo cables. We connect it by following the manual of the bulldozer. For example, Oil pump in channel 7, Tail hook in channel 1. After the connection, set the parameters in RC8X.
Oil pump is in channel 7.
Trim buttons are used to control tail hook, shovel. For example,
DT1--Tail hook up and down.
DT2--Move shovel up and down.
DT4--Push shovel left and right tilt.
(Note: customized voice prompt is available in RC8X(加音频图). Users can make custom prompt voice. Copy the voice into RC8X, and then set the voice prompt for each switch.)
Now we’ll show the set up of the bulldozer on RC8X
Model select-- You can name the model according to your needs.
The bulldozer has 2 motors, 2 ESC and tracks, so we set tank mixing. The left track is in channel 2, and right track in channel 3. So we set Left channel 2, Right channel 3. Turn on the mixing. The tank mixing controls it to move forward/backward and turn left/right.
The bulldozer has a oil pump, which is connected to channel 7.
We assign VR knob switch to control channel 7, which can adjust the speed of the oil pump. The more you turn it, the faster the oil pump runs, and the faster the shovel and tail hook moves. For example, If the oil pump runs slow, the shovel or tail hook will move slowly. If the oil pump runs fast, the shovel or tail hook will also move fast. It is convenient to adjust the speed of oil pump with VR knob switch
We also need to assign 3 position switches to control shovel and tail hook. The four DT buttons can be used as four 3 position switches by setting. We use DT1, DT2, and DT4 as 3 position switches.
Enter Basic menu--"Trim/Dial select" . DT1 controls channel 1, which make tail hook up and down.
DT2 controls channel 4, which moves shovel up and down.
DT4 controls channel 5, which pushes shovel left and right tilt.
After setting the function of DT1, DT2, and DT4, set the step of the three DT buttons to 100, so that every time the DT button is pushed, the travel amount will go directly to 100. Let’s check it. Push the trim button, the servo value will go to 100. The servo value shows 70 here, because I have already set the end point of these channels. Basic menu--End point. End point of channel 1 is 70, 70. Channel 4, 70, 90. Channel 5, 70, 70. You can set the end point as you like. If the oil pump runs fast, you can set smaller end point.
For more details of RadioLink RC8X:
www.radiolink.com/rc8x
Purchase link of RadioLink RC8X:
www.aliexpress.us/item/100500...
You can send mails to after_service@radiolink.com.cn if you have any questions during using our products.
#fpvracing #fpv#rctransmitter #radiolink #rc8x#trending#challenge
Негізгі бет Автокөліктер мен көлік құралдары How to Set Up a Bulldozer on RC8X
Пікірлер: 2