I like that When you didn't get it right the first time you showed how to correct it (rather and re shooting the video.) This is real world conditions instruction. Thank you.
@Melvin_Films
2 жыл бұрын
I ain’t never getting dope on the end of my tape ever. Lol
@KarasCyborg
3 ай бұрын
Thank you! Learned a couple tricks from this video.
@24.7mechanicaltv4
14 күн бұрын
There is just one speed on the Ridgid machine. It's a good speed to "cut" threads in good quality pipe with good quality dies and get the job done.
@harryjackson4682
2 жыл бұрын
Thank you for this! Helped me out incredibly
@lualawok5136
2 жыл бұрын
Big up sir, that is good instructions.
@MK-wi1bj
8 ай бұрын
Thank you for a good video, very helpful .
@w0lf1969
Жыл бұрын
I hate when my help slams that head down. It can move the adjustment then they wonder why it's not threading right. This is the second video I've seen the head slammed down!
@24.7mechanicaltv4
Жыл бұрын
Hey Wolf, you're correct. Maybe just a poor habit of mine. If the spring assist stopper button on the carrige is OK, it should absorb much of the slam. Usually the adjustment should also remain if the adjuster lock rod is tight. But you are right.
@screwheadtx3658
2 ай бұрын
@w0lf1969 Thanks for the info! About to start as a helper and definitely will remember this 👍
@w0lf1969
2 ай бұрын
@@screwheadtx3658 I hope he works out for you. I've been solo for over 5 years only because no one wants to show up to work only on payday
@techabbas5128
Жыл бұрын
Very good Vedo 👍👍👍
@yangyang2693
3 жыл бұрын
Thanks your video!
@mohammadrana4613
6 ай бұрын
I love ridgid
@jjpjjpjjp1
2 ай бұрын
When I line up the die to do any size , and it doesn’t just take . I’d have to help push or it may not even thread . Just strips the pipe . I have to constantly adjust it . Why won’t it thread properly with a nice taper when it’s set on the exact number ? Are my dies bad ? I don’t like this machine
Пікірлер: 22