Ahoy! We have just replaced the Red Rollers with the opaque HighImpact wheels and are having trouble calibrating them so that our saw cuts straight. Right now it is deviating by 5/8" between the start of a vertical cut and the bottom. Even the Milwaukee techs are stumped. I'm wondering if you might have any suggestions. . .
@northernexplorer1709
2 жыл бұрын
I was going to buy one for my shop but if you have to cut that slowly, I'd be broke in a month.
@KevinEvenstad-gj8mt
6 ай бұрын
Hey helpful video
@naushadhosenbacus2732
3 жыл бұрын
Can this be right up against the wall or does the bottom need to be out.
@nathanlockman1554
3 жыл бұрын
Has to be slightly out so that everything doesn't tip over
@dangerousfandango5943
4 жыл бұрын
Why they use the slowest brake saw. It took like 8 seconds to stop lol
@ShakespeareCafe
2 жыл бұрын
Not loud? Wear hearing protection
@davidndahura7437
3 жыл бұрын
Its not good because ripping you have to pull the wood a good panel saw you drive the saw all way as safety feature then its bed is small demonstrate with 4x8 sheet.
@LibertyFabrication
4 ай бұрын
This one costs 2'500 usd, the one you describe costs like 35'000 usd
@DannyDoherty-lt8kw
12 күн бұрын
Can't be good for the back ? All that bending
@jamesmiller1659
8 ай бұрын
To slow, not that accurate. Ok for limited space, that's about it...
Пікірлер: 12