For the rear hub, why not just remove it? They're only held in by four bolts on the backside of the shield. It'd also allow you to easily clamp it in a vise for installing the new studs.
@NickMakesBreaksStuff
3 жыл бұрын
Good point!
@josecampos7461
10 ай бұрын
I like the way he did. The flat rate way.👍
@gasher70
3 жыл бұрын
I am pretty curious why you needed to change those wheel studs. I assume it because of the wheels you got installed. If that's the case, what is special about those wheels that they require such a modification? I just know nothing about why this is being done and I am pretty curious.
@NickMakesBreaksStuff
3 жыл бұрын
Thanks for watching! The OZ wheels that I purchased had a thicker mounting hub area than the stock wheels, so when I installed them, there wad not enough of the stud sticking out to thread my lug nuts on. The extended studs are about 25mm longer, so problem solved Another reason for longer studs is if you want to use wheel spacers.
@1998gst4611
2 жыл бұрын
@@NickMakesBreaksStuff and they also look cool
@1998gst4611
2 жыл бұрын
Whats the ARP part# on those wheel studs? Obviously ARP doesn't list a set of wheel studs for Hyundai vehicles could this be cross referenced with other car manufacturers that will work on on the hyundai like honda or suburu or mitsubishi?
@pjr1012
Жыл бұрын
Was it the front end where the dust shield is In the way?
Пікірлер: 9