In this video we cover how to setup a Raspberry Pi Pico as a secondary MCU and pair it with an adxl345 accelerometer to run input shaper with Klipper
USEFUL LINKS!
www.klipper3d.org/Installatio... - Install Klipper/Make Firmware Flash File
www.klipper3d.org/Measuring_R... Setting up IS with accelerometer
i.imgur.com/MFl3WGF.jpg ADXL to PI PICO wiring
www.amazon.ca/Monoprice-10656... USB keystone jack, use this or a male-female usb cable so you no longer need to flip your printer to get at the RaspPi
adxl.cfg
##
[mcu adxl]
serial: /dev/serial/by-id/ PUT SERIAL ID HERE!!
[adxl345]
cs_pin: adxl:gpio1
spi_bus: spi0a
axes_map: x,z,y
[resonance_tester]
accel_chip: adxl345
probe_points:
150,150, 20 # middle of bed as an example
##
0:00 INTRO
0:48 Why use a rpi PICO
1:46 Making the wire harness
5:45 Firmware Install
8:24 Connecting Pico to Printer/Setup Configuration
12:05 How to install on OTHER printers
13:35 OUTRO
If you like what you see and want to help support the channel?
Consider becoming a channel member!
/ @canuckcreator
Or join my patreon
/ nero3dp
Need a new hotend or extruder? why not check out e3d
e3d-online.com/?aff=12 (affiliate link)
s.click.aliexpress.com/e/_AlSJoV -aliexpress affiliate link
Looking for a great first 3d printer? Grab an Ender 3 V2 from the affiliate link below, get a great deal on a machine AND help the channel out in the process.
www.banggood.com/custlink/vmK...
Need filament or a printer? Purchase anything from MatterHackers with the link below and a portion of the sale goes to supporting the channel
www.matterhackers.com?aff=7543
I NOW HAVE A TWITTER, follow me @ / 3dpnero
Негізгі бет Ғылым және технология Input Shaper with a Pi Pico - Klipper Tips
Пікірлер: 285