In this installation video, we show you how quickly and easily you can set up and install our insect screen for your window. Suitable for the following Windhager products: 04336, 04337, 04338, 04339, 04527, 04528, 04529, 04530
Tools needed: rubber mallet, rolling metre, pencil, scissors, cutter, hacksaw, file, screwdriver, cutting tray.
Step by step to the perfect insect screen:
00:00 Unboxing
00:16 Measure the clear width dimension B by measuring the horizontal inside distance of the open window.
00:23 Measure the clear height H by measuring the vertical internal distance the vertical inner distance of the open window.
00:29 Determine the frame thickness.
00:35 Calculate the measured length B minus 20 mm.
00:49 Note the measured length H.
00:57 Calculate the measured thickness X plus 3 mm.
01:11 Mark the elements with the calculated measurements.
01:31 Shorten the profiles at the marked points with a metal saw.
01:37 Deburr the cut surfaces on profiles with a file.
01:42 Connect the sections with corner connectors to a frame.
01:55 Place the sealing brush on the outward upper groove of sections and press it with the thin tip B of the welt tool in die groove.
02:03 Shorten the sealing brush with scissors to match the recess length.
02:07 Roll the material over the frame.
02:11 Attach the material with a rubber welt to the welt groove. Use the wide side A of the welt tool to do this.
02:20 Shorten the welt with scissors after you have attached it all around.
02:28 Shorten the material outside along the welt with a cutter.
02:34 Bend the four fastening springs using the bending device to the calculated bending dimension.
02:38 For this purpose put the fastening springs into the bending device as shown and bend them to a 90-degree angle.
02:56 Attach the lower suspension springs 30 mm away from the frame.
03:04 Attach the upper suspension springs away from 36 mm the frame.
03:12 Fix the suspension springs with the screws.
03:20 Link the left and right grip elements to the units and insert the metal pins into the recesses to connect.
03:32 Screw the grips left and right with screws into the screw groove of the frame sections.
03:38 The insect screen is now ready for mounting.
Open your window and place your insect screen frame.
03:42 Guide the upper suspension hooks into the blind frames from
outside.
03:46 Pull the frames in and push them out so the lower suspension springs attach behind the blind frame.
Негізгі бет Insect Screen window from Windhager Home & Garden - Mounting instruction (QA570)
Пікірлер