In this tutorial, our objective is to help all boat owners become CONFIDENT in laying an inside patch to repair any holes/tears near the seam of their PVC boats. This process can be applied to Hypalon boats while substituting for the proper chemicals. The purpose of laying an inside patch is that seam on a boat creates a slightly elevated surface, making it impossible to have a permanent air-holding patch, that under pressure forces the air out along the seam. By laying an inside patch it seals the leak simply because the inside of the boat is flat. A flat surface is essential in successful lifelong boat repairs. Please see our introduction film for a safe and successful assessment of repairs.
This tutorial does not include the second patch one would need to lay on the outside of their boat.
Please refer to the NRS website with questions regarding BASIC repairs www.nrs.com/le.... or call Trailhead River Sports with any questions at (406) 543-6966.
Required Materials:
PVC or UrethaneTube Material
Methyl Ethyl Ketone (MEK) or you can also use acetone
Clifton Urethane Adhesive
Pro Roller Hand Tool
Sharp knife
Stiff Bristle Brush - 4-ounce can have a brush in the lid.
Chemical Resistant Gloves (i.e. Nitrile gloves)
Eye Protection
Pencil
Fine Sandpaper (~ 180 grit) or Roller Rasp
lint-free Towel
Organic Fume Respirator
Warning for all Glue and Solvent Use: The use of these products can be very dangerous and can have short-term and long-term consequences to your health. It is important for you to take precautions and wear all appropriate safety gear. Wearing gloves, a respirator, eye protection, and working in a well-ventilated area can go a long way towards mitigating these risks.
Негізгі бет INSIDE PATCH comprehensive SEAM REPAIR for PVC and Urethane Boats
No video
Пікірлер: 18