Thank you to everyone who has left a comment (or will) on how I could have made/utilized Sprue Goo to better effect. I love how helpful this community can be. Clearly I have some work ahead of me, and I think I owe it to Sprue Goo to give it another chance (or 3).
@GDSMiniatures
Жыл бұрын
Others have already said what i came her to say, when you dry fit the model and you see a gap, use sprue goo to stick those bits together. Much easier time of it. I think, however, post assembly green stuff is better Great video sir.
@wolfassassin359
Жыл бұрын
My best trick for gaps is to use sprue shaving on top of plastic glue in the gaps and form it with the knife.
@TableTopAckley
Жыл бұрын
That sounds way better than my just "glob it all on" method. I'll definitely have to give that a try.
@liamhobbs1401
Жыл бұрын
I tend to use a bit of glue on gaps and file it, filling the gap with the small plastic bits that the file takes off. Works pretty well but not on every surface. As others said, you definitely needed to thin it down more!
@TableTopAckley
Жыл бұрын
Clearly I needed to do a few practice rounds! I really appreciate the advice you and everyone else are providing.
@liamhobbs1401
Жыл бұрын
@@TableTopAckley No worries, thin enough sprue goo can be used throughout the entire assembly. Pete The Wargamer used this in his recent Soulgrinder video.
@herrpflichtfeld9181
Жыл бұрын
If you mix GS with Milliput it will get so much smother to work with
@jasonstatham5879
Жыл бұрын
What if the sprue goo was applied when the pieces are put together and the seam cleaned up at that time?
@TableTopAckley
Жыл бұрын
I'm picking a model to test this on already. Based on yours and the other comments already made, I owe sprue goo another chance.
@Godeater42
Жыл бұрын
Try using more acetone/glue.
@JaiPritchett
8 ай бұрын
2:54 Wait for 24 hours but in some cases ok in a hour :P WTF
@octavio1276
Жыл бұрын
☀️ ᑭᖇOᗰOᔕᗰ
@RozzCraft
Жыл бұрын
Imo, there wasn't enough acetone in your goo. I don't have as rough a time applying or spreading it with the tamiya mix I use. I also don't think you explored the largest pro, that you can use it as an adhesive to gapfill as you assemble the model. I could see it being difficult with the consistency you ended up with, but more solvent should make it convenient to paint on.
@TableTopAckley
Жыл бұрын
Thank you for the advice. I'll have to tweak my process and see how it improves things.
@Caseytify
Жыл бұрын
^^^this^^^
@BbBb-zx6sx
Жыл бұрын
Your sprue glue was too thick. More acetone to sprue ratio.
Пікірлер: 17