Great video I learned alot,is the clutch assembly on your 720 the same as a 620 ?
@oakwoodstockfarm7017
4 ай бұрын
Very similar, 720 is a bit bigger and I think has more discs
@user-wu5gg6wq5w
4 ай бұрын
@@oakwoodstockfarm7017 thank you
@jhurt4227
9 ай бұрын
1. Can the grease fitting at 7 miniute into your video be reached w/o removing entire belt pulley assembly? 2. How far does the right rear wheel need to be spaced to pull off belt pulley? 3. My only 720 D clutch issue is a very stiff over-the-top movement. Any suggestions? 4. I am a healthy, fairly strong 82 Y. O. , but I am concerned. How heavy is the belt pulley you remounted?
@oakwoodstockfarm7017
6 ай бұрын
The grease fitting can only be reached if the pulley assembly is removed. There’s about 8-8.5” between the pulley and the rear tire, it was tight but I was able to get it out. The pulley assembly is probably 40lbs. Check out our clutch adjustment video, might need some tinkering if it’s too stiff
@ericpolach8507
7 ай бұрын
Did you have to remove the rear gear to get the shield off to reach the dogs
@oakwoodstockfarm7017
4 ай бұрын
Nope, on the earlier models I think you might have to but not 100% sure
@michaeledler2968
2 ай бұрын
what is the best grease to use on the dogs and toggles
@oakwoodstockfarm7017
2 ай бұрын
Any bearing grease will work, I use the traveller brand from tractor supply
@michaeledler2968
2 ай бұрын
@@oakwoodstockfarm7017 thanks also when u put the pulley back on did u use anything on the oil seal
@oakwoodstockfarm7017
2 ай бұрын
@@michaeledler2968 if you’re talking about the gasket against the tractor, I did not use anything besides the gasket itself, no issues
@kurtisharrington6015
Жыл бұрын
okay now ive got a jd 50 and had to go through my clutch. where did you find the pin? on Steiner i could not find one
Пікірлер: 15