How to disassemble the connector? The orange rubber part looks quite squeezed into the connector. How to pull that out when all 6 wires used?
@NucularElectronics
Жыл бұрын
You will need a needle to pull plastic part to release pin, then sligtly pull wire to move pin away a bit, repeat that for all pins and then seal can be extracted together with all pins same way as i showed on video
@LTVoyager
9 ай бұрын
The JWPF training video at DigiKey shows crimping the terminals on first and then pushing the terminals through the seal and not removing the seal from the connector body.
@NucularElectronics
9 ай бұрын
I made custom JWPF seals that stay waterproof when there is no wires inside, also it is made for smaller wire diameter. So assembly procedure is different.
@АндрейМельченко-л1л
Жыл бұрын
What tool do you use to crimp contacts? What set of stamps?
@NucularElectronics
Жыл бұрын
Tool is SN-03BM
@lhk8558
6 ай бұрын
@@NucularElectronics Will the crimper used for Onboard display connectors ph2.0 also crimp these JWPF connections?
Пікірлер: 8