I didn’t do a video on removing the console because it was so easy. If I remember correctly it was 3 or 4 screws then pull up on the shifter to remove it then the whole console will come out. I send out my srs modules to get the crash data erased. You can find a lot of company’s on google that offer this service for reasonable pricing. Even after the crash data is cleared you have to make sure that any damaged or deployed srs components are replaced for the air bag light to go out. For example this car had a deployed steering wheel bag and a deployed seatbelt tensioner for the driver seat.
@slytechgaming
6 жыл бұрын
Thanks for the help
@GLeszega
6 жыл бұрын
slytechgaming glad this helped!
@z3RosIK3
6 жыл бұрын
Did you ever do a vid to remove the center console? Also how did you reset the hard codes or crash codes? Do you have to replace the deployed airbags for the srs to go away? Thanks
@GLeszega
5 жыл бұрын
z3RosIK3 hey sorry for replying so late. I didn’t do a video on the removing the console because it was so easy and there are a few videos out there on it already. Yes, I sent the srs module out to have the crash data erased. The srs light will not go off after the bags and seat belts are replaced you have to either get a new srs module and program it or send it out to be reprogrammed.
@fishingadventure7065
5 жыл бұрын
@@GLeszega do of to reprogram the module
@Fuckzionists
5 жыл бұрын
Thanks man
@GLeszega
5 жыл бұрын
Raouf M-b glad it helped 👍🏼
@Fuckzionists
5 жыл бұрын
Did you reset the module? Or you changed it? Did it work?
@GLeszega
5 жыл бұрын
Raouf M-b I sent it out to get reprogrammed along with the seatbelts to be rebuilt. Yes everything worked and there was no srs codes. I can’t remember where I sent it because this was a couple of years ago.
@massesbulet
5 жыл бұрын
Where i can get the module cheap because The car i found it has The Steering wheel airbag pop out
@JuanMartinez-ey7kc
4 жыл бұрын
Hey did this make all your air bags able to deploy again
@mdorgha
5 жыл бұрын
I dont know how you can say the 2 botls in the back are easy to remove, i tried every tool i have to get to them, i still cant get there. It s at such an impossible angle to work at. Cheers if you got it done.
@GLeszega
5 жыл бұрын
Zied Dorgham it’s been so long since I did this one so I don’t remember every detail but I think I had to use a 1/4 drive ratchet because it was smaller then I went in through the gap on the right side in between the metal frame. Hope this helps.
Пікірлер: 16