My story, I had the same thing and Woo support guys were so nice, just tell me that the tightness is broken and there is corrosion and we can't help you at all just give 20% discount on the same Woo 3.0 v with the same problem. I said and whose fault is it? You know about that problems but you say nothing and don't want replace it? Great service) I would like thank you for your video it will safe money for a lot of kiters.
@jamiealexander9008
Жыл бұрын
I have made this operation with three different woo sensors now. Can I just add I have now taken an old bicycle inner tube and cut it into band sections to loop in a cross formation over the transparent woo case because many times the blue closing clip becomes undone while riding. This has saved my woo from being lost many times. Great video.👍
@carstenmarquardt4377
4 ай бұрын
Really nice explained Video 😃. Is it possible to change an old battery with low capacity?
@TomKitesurf-Passion
4 ай бұрын
Im sure you just need to check the voltage and mha(capacity) and of course dimensions to fit in the case. Im sure on ebay there are all kind of litium batterys to find. My was still ok and after over 6 month still ok. After 2 hours session battery is at 75%
@n.erhantanrkulu665
Жыл бұрын
Amazing solution, same thing happened to me. I wanted to disamble it but my little screws were damaged. I will try the rest after I manage to unscrew them :)
@TomKitesurf-Passion
Жыл бұрын
Yes try to drill them out with a 3mm drill, hope for you to get your woo fixed
@n.erhantanrkulu665
Жыл бұрын
@@TomKitesurf-Passion Thanks for the tip, will try it!
@SunshineDenmark
Жыл бұрын
@@TomKitesurf-Passion they are only screw into plastic it should be possible with a sharp right size screwdriver to get it to bide and unscrew 🙂
@TomKitesurf-Passion
Жыл бұрын
@@SunshineDenmark maybe yes in my case sadly not :) wish you good luck for your repair! And let me know if successfull
@scottkeegan1007
8 ай бұрын
I have four useless WOO's tried what you did, all worked, but I didn't have damaged pin like you. WOO takes charge, but will not power, once removed from charger, is battery toast?
@SunshineDenmark
Жыл бұрын
cool, video. my charging pins are also almost disappeared due to corrosion. It would be great if someone new the part no. for the pogo pin's used ?? then I would be able to fix min. Also one thing I noticed if you cut out the foam where the terminals are in casing then you definitely have way less corrosion (due to always a little moisture you will have current traveling between contacts through the foam and that cause the corrosion)
@TomKitesurf-Passion
Жыл бұрын
With the foam its a good tip, i some rubber glue on that position to seal it hopes that helps. Maybe a option for the pins are a small 2pin plug from a old electronic device i know them from car rc batterypacks like this www.ebay.de/itm/222864736648?mkcid=16&mkevt=1&mkrid=707-127634-2357-0&ssspo=qv4BVfRZSMK&sssrc=4429486&ssuid=ThKZ9mp8Tu6&var=&widget_ver=artemis&media=COPY
@stijnvanroessel
2 ай бұрын
I fixed the charging pin which seemed to be stuck, but still the Woo won't charge more than 1%. It connects and says charging on my phone but it keeps stuck at 1% battery... Any other solutions? :)
@TomKitesurf-Passion
2 ай бұрын
@@stijnvanroessel it could be that the charge controller is damaged or battery. I bet on the battery maybe you find a similar battery on ebay/battery stores with same size/voltage and change it.
Пікірлер: 14