Hi Jay, you did a real good job taking all those parts off. I thought those bolts and nuts would be hard to get loose, but they all came loose and came off just right. Can't wait to see the next video. This really was a great video. Pete
@1995jug
11 жыл бұрын
Well you got her to the nitty gritty I thank you are right the bar is steel you might be able to weld some small patches over them holes if they don't get in the way of blades.
@nelsonguier2922
Жыл бұрын
Yes. Got pretty ruff with it and didn’t want to break anything. I put a crowbar under it and tried to pry it off but couldn’t get it off.
@farmboy30117
11 жыл бұрын
Thanks Pete. They were a little difficult. Not as bad as the ones in the next video.
@farmboy30117
11 жыл бұрын
I think to be safe and not have to worry about it for awhile I'm going to replace both halves. With the bottom being so pitted, it'd just be a matter of time before it sprang a leak somewhere else.
@nelsonguier2922
Жыл бұрын
I wanted to see how to get the turtle hats off 😫
@farmboy30117
Жыл бұрын
They are bolted on.
@nelsonguier2922
Жыл бұрын
@@farmboy30117 I took the 2 bolts off on top of them and can’t get them off. So what is the trick before I tear them up?
@farmboy30117
Жыл бұрын
@@nelsonguier2922 Maybe they're rusted to the bearing hub? We are talking about the blade holder, correct?
@rickthompson6920
2 жыл бұрын
I used a torch on back bolts and replaced with new ones
Пікірлер: 10