Thanks so much for taking time and making this video help me
@lannysalisbury6645
4 жыл бұрын
Very informational Thanks
@mralexlopez2012
3 жыл бұрын
Did you use the lines on the new belt to align the belt with the markings on the cam and crank? I'm assuming you did but you didn't mention using the reference lines on the belt.
@SteelBlue911
5 жыл бұрын
Good job, primo!
@FranciscoGonzalez-ro7ht
5 жыл бұрын
Debe quedar floja cuando removiste el clip note que se vehia floja.. debe tener tension fuerte o no.
@peternguyen496
Жыл бұрын
Please show where you put the screw driver
@marufzhanzaitov6535
4 жыл бұрын
You didn't show where you put screwdriver?
@peternguyen496
Жыл бұрын
My crank shaft on engine #1 the mark doesn't not line up what should I do?
@paulroggemann1017
2 жыл бұрын
GOOD LUCK
@michaelwu1282
3 жыл бұрын
Good afternoon!! Can you just remove waterpump?
@IDGAF56852
Жыл бұрын
You didnt line up the camshaft and crankshaft lines on the belt with the timing marks on the 3 sprockets? This is a big no no,if you skip a tooth you wont have a reference to go by. You must follow these processes by the book.
Пікірлер: 12