Hey very good video those fridges really give a lot of problems when they ready especially the 3 way valve and compressor
@imtiyadkhan1349
9 ай бұрын
मैं इंडिया से आप कहां से हो आप की विडियो से बहुत कूछ नया सीखने को मिलता है
@carlosabreu4099
6 ай бұрын
I’m have Kenmore elite refrigerator I test with nitrogen all line are all open, once I add refrigerant and run the refrigerator it goes into vacuum any thoughts if I have to replace the 3 way valve
@sergioterrones8724
2 ай бұрын
I'm having the same issue
@carlosabreu4099
2 ай бұрын
@@sergioterrones8724 in my case I had restrictions you going have to take off both line from the compressor high and low installed a service port high side connect your gauges and add nitrogen 250 or high. plug in the fridge until you see nitrogen comes out in the low side unplugged the fridge. Connected the lines back to the compressor, vacuum it and add Freon again
@mezike23
6 ай бұрын
When you check pressure and you get air on FF side should you also get air on FZ side as well? (In the case you had the FZ cap line cut)
@user-bd2qk5qe6s
7 ай бұрын
What was the pressure when you inspected it for the first time?
Пікірлер: 8