Hi Adam, Well done mate I knew you do it in the end, I will now try you new link, You take care of yourself and stay safe.🛠️🛠️🛠️⭐️👍
@brianleduc2244
11 ай бұрын
Great job as fixing it problems only major problem left is the spark plug!! If it was me ill be taking a measurement from the heads face to the piston at TDC to make sure there's room for the plug without piston running into the end of it !!takes a 2 min to know ,,, keep going.,!! The little engine is bagging to run for its frist time
@trevorjones4463
11 ай бұрын
Hi mate if you go hit and miss you need breakers on the cam gear all the best trevor
@markjeep9415
11 ай бұрын
Can't wait to see it running.
@matnaylor8939
11 ай бұрын
Gonna be fun seeing it ticking over , try a radio control car ,plane plug for the sparkles ??.
@shedhead00
11 ай бұрын
Maybe the key is a immobiliser device. Heading over to look at your new channel
@enginecrzy
11 ай бұрын
Squared away propper.👍 If memory serves, Keith Appleton mentions on his steam models yt page were to get model brass & glass oilers, He's also in the UK. I do know he likes to use Blackgates engineering model supplies allot, they are in Dewsbury but have a webpage as well....✌👍
@TerryLawrence001
11 ай бұрын
The bolts might not by strong enough to hold the cylinder on under working forces. Maybe you can redo the slots and make a new key that lines it all up?
@TheTutorialguy_28
11 ай бұрын
Looking a good engine now, are you going to give her a lick of fresh paint as the old paint seems a bit well old? Unless that's just thr camera flash but anyways great vid can't wait to see her going, will check out the new channel too 👍
@trevorjones4463
11 ай бұрын
Don't spin it that way to start it go the other way 😂
@whitesapphire5865
11 ай бұрын
For the sparkplug, how does the tiny little plug from the Honda E300 portable generator match up for size?
Пікірлер: 14