Part 2 covers installing the push rods, rocker arms and the valve covers.
It is important to get the lifter/push rod on the base circle of the cam before tightening down the rocker arm so that you don't over-stress the rocker bolt threads in the head.
On ported heads, likely the intake rocker arm bolt hole becomes a through hole into the intake runner. In which case, be sure to use some thread sealer on that rock arm bolt so that oil doesn't seep past. (not shown in video)
FelPro Valve Cover Gaskets w/bolt grommets - VS50504R1
amzn.to/2EhEbsF
The FelPro gaskets are much cheaper than the GM gaskets for some reason, but just as good.
GM MLS Head Gaskets - 12498544
amzn.to/2sky69x
GM LS7 Lifter Trays - 12595365
amzn.to/3dhCvvZ
GM LS7 Lifters - 12499225
amzn.to/2V00CJu
Lucas Assembly Lube
amzn.to/2Ckl5SA
Негізгі бет LS Tech: Cylinder Head Install - Part 2
Пікірлер: 72