You guys did good. Especially clean up after reassembly! That is being a professional!
@kwh4754
3 жыл бұрын
Really well done - thank you. It could be a difficult edit [expletives...lol] but sometimes its nice to see when the trouble spots are encountered and overcome (drive and prop shaft disconnect/clearance).
@gillescartron3178
2 жыл бұрын
Vidéo très bien faite, j'avais de gros claquement à l'accélération, j'ai décidé de changer ma boite de transfert seul en suivant vos explication. bilan : en 1 jour et demi j'ai changer la boite avec succès. plus de claquement. merci beaucoup.
@jeffr5053
3 жыл бұрын
Bearing and chain overhaul for the same component would be a good video to film.
@12345678916510
Ай бұрын
Thanks for the vid. I have a 14 gl550 doing the same
@cosmovrun185
3 жыл бұрын
Hi Great video, just wondering i s 2014 ML350 w166 Bluetec the same?
@rp1268
3 жыл бұрын
I have a humming and scraping noise when driving on the highway. I replaced the front wheel bearings and that didn’t fix it. The mechanic swapped out the front differential with a used one and that didn’t work either. He says it’s the transfer case. Could it be making a scraping noise though? Scraping is more pronounced when going on the highway and turning the wheel slightly around bends. Thank you
@9186SZ
3 жыл бұрын
Great video, well explained thanks for posting
@lukman8400
2 жыл бұрын
Thank you! Is this also applicable for glk 350 2010?
@joshuathill6630
Жыл бұрын
hey did you change any seals/ gaskets on the transmission side, if so what?
@critian19747
2 жыл бұрын
great video ,,how mush price of labor
@caxuxi1
Жыл бұрын
Where you get those seals
@wolfgangy9075
2 жыл бұрын
Hi.I have the same issue....where can I found you?
@centrotecbauru-speder
3 жыл бұрын
Hi . I'm from Brazil 🇧🇷🇧🇷 What is the correct fluid for this transfer box?
@silvianenova6455
2 жыл бұрын
Mercedes benz 236.14 MB 000 989 68 05 11 ATF
@centrotecbauru-speder
2 жыл бұрын
@@silvianenova6455 thank you so much!!
@dealman3312
3 жыл бұрын
Awesome video. Do you see leaking transfer cases on 2014 GLK 250?
@CarcraftAutoRepair
3 жыл бұрын
yes, the rear covers leak on them.
@andrewb8961
4 жыл бұрын
Hey man. Great video. What is the labour time for this job?
@CarcraftAutoRepair
4 жыл бұрын
Thank you. 3.3 hours is the labour time in Alldata.
@FZERO20
4 жыл бұрын
ANDREW B I work at the dealer and literally just did this job, it pays around 8 hours if you do all three seals. Also you don't have to remove the exhaust to remove the case
@CarcraftAutoRepair
4 жыл бұрын
@@FZERO20 I used to work a Benz as well. Gettin that gravy 8 hours. Lol.
@malshami20
4 жыл бұрын
Good video. What is the labor on such a job runs ??
@CarcraftAutoRepair
4 жыл бұрын
Thank you, I dont quite recall exactly but about 3-4 hours I beleive.
@CookJunkie
3 жыл бұрын
Man... Owner of this vehicle is lucky it isn't the oil cooler gasket that goes bad in these w166.
@CarcraftAutoRepair
3 жыл бұрын
Ive done probably over 100 coolers. No 164 or 166 gets away with without replacing them. Keep it long enough and itll need to be a 2nd or 3rd time. Junk lol
Пікірлер: 27