Great Video! I will change them now because I been getting this code a lot.
@rzrtuber566
2 жыл бұрын
Great content dude. Just found your channel. You have some good videos on here.
@SpangsWorld
2 жыл бұрын
Thanks.
@kevinsmith-kg1nv
2 жыл бұрын
great video. mine is throwing a code after this weekend will see if this is it.
@mchugh601
11 ай бұрын
Put it in Neutral and rev it to over 4K rpm for 10-60 seconds to clear the check engine light
@SpangsWorld
11 ай бұрын
Might have to try that.
@ethanh9535
2 жыл бұрын
What do you mean by misfire? Was it like backfiring when slowing down or what? Thanks.
@SpangsWorld
2 жыл бұрын
Basically the spark plug is not igniting normally due to an old spark plug that is worn out. Could also be the coil pack for the spark plug. I always Starr with the less expensive part. Hope that helped.
@ethanh9535
2 жыл бұрын
You wouldn’t happen to know what causes clunking noise on the right side of a RZR 1000 S? Any help would be appreciated. Thanks.
@SpangsWorld
2 жыл бұрын
@@ethanh9535 is it right when you start to move. Mine makes a clunking noise when I start to move from a stop. Believe it's more of the play in the rear end. I'll look into it some more and see.
@yoofaceee514
Жыл бұрын
Mine has a cylinder misfire on cylinder 3 and loss power u think it’s spark plugs?!
@SpangsWorld
Жыл бұрын
That's where I would start. Spark plugs are like $5.
@jamesmason8593
2 жыл бұрын
Great, now how do I get my check engine light off
@SpangsWorld
2 жыл бұрын
According to Google. To reset the ECU, you have to disconnect the battery completely. Then touch your RZR's wire harness terminals together. This will drain the capacitors and anything else in your ECU that holds a charge, and is a guaranteed method of resetting your Polaris RZR's check engine light
@SpangsWorld
2 жыл бұрын
If you have more codes or need an oil change it will stay on.
Пікірлер: 17