Part alignment process for making a program to measure different parameters
@RAHULDAS-cr5fl
2 жыл бұрын
Sir how to measure flatness perpendicularty and roundness plz make a video on this topic
@bobbauvian7700
2 жыл бұрын
this great thank you very much. do you have a video showing how to write an alignment program on a manual machine.
@machinisttodd
2 жыл бұрын
I haven’t used a manual machine in a very long time. I would imagine it would be the same as doing an alignment on a cnc type but you would have to just move the probe by hand. Thanks!
@NateFreelRacing53
2 жыл бұрын
For the manual alignment will the cmm compensate for height changes based off of fixturing? Say I com back to a set of parts after 6 months and I do not use the exact stanchions that had been previously used. Thank you this has been a great video series you have produced.
@machinisttodd
2 жыл бұрын
As long as you do an alignment before you start measuring you should be good. The initial alignment will set the plane height even if you use different height stanchions. Thanks for asking!
@edgardelgadorivera5151
Жыл бұрын
Can you show how you did in the screen software?
@joecarosiello4672
3 жыл бұрын
Is there a way to rotate the probe with the joystick? Moving it 90 degree angles etc?
@machinisttodd
3 жыл бұрын
If it is I don’t know how to. I’m not saying you can’t but I’ve never been shown how.
Пікірлер: 10