As far as I know, the communal hole escapes faster than the intake hole so the communal hole does not need to be too large
@c__TattinhNhi
3 жыл бұрын
I mean, the hole is smaller than the 1mm intake hole
@mtlife4474
3 жыл бұрын
Is the intake hole you say on the carburetor side? If so, As far as I measured AB27 cylinder , there was a difference of 2mm ( Cylinder side is bigger). With a general engine, it should gradually become thinner toward the cylinder , I think it was intentionally designed because the engine speed become too high. I tested it in the next video, but since the engine rotates at 11000 rpm in this processing, I think that it will break unless other parts are replaced.
Пікірлер: 26