No need to watch this one, it was more for my benefit and testing the PIP with the second camera.
So, the two screws holding the head support column were loose. That was part of the problem. The next problem was the laser lens which was not parallel to the bed, that was corrected by adding a 0.8mm washer to the bottom screw after loosening all the screws. The lens is now perfectly parallel with the bed.
I then found that the laser can't produce a simple large rectangle without errors in the geometry.
This now needs a Galvo Calibration carried out.
Mr Carve M1 Pro Rotary Roller video
• Flipper Zero. A very i...
M1 and M3 support group
/ 642871350193744
TV Engineers Forum
t-m-f.uk
GHD Hair Straightener Repairs
ghd-repair.co.uk
Gifts for friends and family.
gift-parlour.c...
Негізгі бет Mr Carve M1 Pro Alignment Problems
Пікірлер: 2