Thanks for these videos on the MU2. Had a bit to do with the engines for this airplane back in the day.. Hope you keep doing these great videos.
@dr62220
2 жыл бұрын
The airframe is one thing, the real cost is in the turbines. Have worked on dozens and dozens, and completed HSI, gearbox inspections and complete overhaul's on 3-4 times that many Every time that little gauge goes over that little red line put several thousand dollars in a jar. Your going to need it. However this aircraft and the Turbocomander are some of the best aircraft that were made. MU-2 came to the US in a box and were assembled in San Angelo Texas.
@bluefishbeagle1
2 жыл бұрын
Turbine of all makes do not take abuse without cost. The TTPE331-10 is a robust engine that can run and make power even with lots of heat damage, of course at teardown things get expensive. In 2008 we paid 175K per engine for overhaul, the prices now are much much more. but still less than Pratts..
@n89434
Жыл бұрын
In the early-mid 70s, I grew up near SJT. Still recall rows of these still green, out on the ramp, others painted. I’ve always had a soft spot in my heart for the MU-2.❤️
@gendaminoru3195
7 ай бұрын
not bad to go down, but we really need the gear to retract faster - it coudl be a matter of life or death...
@bluefishbeagle1
7 ай бұрын
Engineers are not pilots and often forget they are passengers..
@didierdebaere7193
18 күн бұрын
King air does retract in 5". Mitsubishi should be upgraded in that sense.
@twoturnin1
3 жыл бұрын
Had a door limit switch fail on my F model going into KLIT on a two day Lowes Co trip. Tower says are you needing assistance. I say nope just 252 cranks and 3 greens !! No problem . Opppps this was in 79.
@bluefishbeagle1
3 жыл бұрын
this gear swing was needed because the forward right door switch failed and sheared the shear pin.
@MrTaylorKiel
8 ай бұрын
Super sweet.
@transporterdispatch231
3 жыл бұрын
What is 100 hours cost for this plane? By the way, thanks for your advice, I finally figured out how to landed this plane. I still have some questions, but it's hard to explain without pictures.
@bluefishbeagle1
3 жыл бұрын
Most MU2 aircraft follow the manufacturers maintenance program. No annuals. The basic inspections are the 100 hour, 100/200 hour. There are many others each one looks at items as they come due. A 100 hour is about 4K plus squawks, parts etc.. It will run 8K on the low end and might go into the mid teens but not every time. The MU2 as turboprops go is one of the lower cost aircraft when it come to maintenance. Plus burning 10 percent less fuel than say a King Air 200 makes it overall less to own.. The purchase price of any turboprop is really just the initiation fee. LOL
@transporterdispatch231
3 жыл бұрын
@@bluefishbeagle1 How long takes for you make it 200 hours? One guy in KZitem had his own MU 2, he made some videos, but then he sold this plane. Must be very hard pay all 100-200 inspections and make a living. What was your first feeling flying MU2? Lots of pilots saying it's very dangerous plane, because of spoilers, specially if you get ice on it. Can you please tell me about your experience. Thanks
@_PPHS
3 жыл бұрын
@@transporterdispatch231 as a mu2 pilot I can guarantee it is a safe airplane. I would say (maybe in the past) the mu2 was missunderestood due to its features and especially lack of training. Mu2 it's a high performance turbopropeller and requires careful when operating, but she will take you everywhere you want under a low cost.
@transporterdispatch231
3 жыл бұрын
@@_PPHS Thank you for answering back to me. I'm beginner in aviation, only 140 hours, flying my IFR hours. For some reason I like MU2 but I never saw this plane in reality. I fly this plane in Xplane 11. And sometimes I have a questions. Too bad Xplane don't have check lists for planes, would be lot easier understand what and how to operate.
@_PPHS
3 жыл бұрын
@@transporterdispatch231 google "Mu2 pilot check list eastaire", there is a fine material to dowload in pdf. Following that, will be more realistic your operations on fsx. All the best and safe flights!
@bermudarun3903
3 жыл бұрын
And that’s how it’s done. Thanks
@bluefishbeagle1
3 жыл бұрын
Those guys are pros, MU2/Lear Jet specialists.. been doing our maintenance for 12 years... many good shops around for the MU2 we are fortunate to be close to several. ICJS in Tulsa is also very good...
@Booboobear-eo4es
3 жыл бұрын
Sounds like a ridiculously loud vacuum cleaner.
@bluefishbeagle1
3 жыл бұрын
When you put the gear switch down in flight it sounds beautiful, (silence is not always golden) ha ha
@ryancadwallader2049
3 жыл бұрын
Thankyou! I've been looking for exactly this video ! Any chance you can do a video of the linkages etc?
@bluefishbeagle1
3 жыл бұрын
will be a while before next inspection and gear swing , could do one static if you are interested
@ryancadwallader2049
3 жыл бұрын
@@bluefishbeagle1 absolutely! Any info regarding the main gear will be greatly appreciated.
@ryancadwallader2049
3 жыл бұрын
You can send photos etc to me on FB if thats easier.
@twoturnin1
2 жыл бұрын
Beagle you still kicking hope all is ok with all this Covid mess etc etc.
@bluefishbeagle1
18 күн бұрын
Still here, hope to have some more videos soon
@didierdebaere7193
18 күн бұрын
That is long really. A King air does it in 4-5 seconds with doors closed. I wonder if it could be reduced in time
@bluefishbeagle1
18 күн бұрын
The gear doors double the extend/retract time. On the plus side the gear is super tuff and cost to maintain is a faction of the King Air
@twoturnin1
3 жыл бұрын
Beagle how ya doing still kickin I hope !
@bluefishbeagle1
3 жыл бұрын
Yes just I am. I've been lack on updating and posting new videos hope to correct that soon thanks for asking
@dyno007cro
2 жыл бұрын
How exactly are nose jacks holding it up? Are pads bolted on?
@bluefishbeagle1
2 жыл бұрын
Yes screwed to side suppoerts
@RobRamirez456
3 жыл бұрын
Everything is loud in a MU-2 lol
@bluefishbeagle1
3 жыл бұрын
What? say again... louder please
@RobRamirez456
3 жыл бұрын
@@bluefishbeagle1 I SAID EVERYTHING IS LOUD IN A MU-2 MATE
Пікірлер: 40