Nice. I'm getting ready to put a 5.3 I got for $50 in my 85 chevy k30
@acollins9277
3 жыл бұрын
Always great info.
@JovaniDanteGriego
3 жыл бұрын
Thanks!
@car-toonnetwork7723
2 жыл бұрын
How did u find the correct engine mount on ebay did u just search 5.3 engine mount for c20? Plz get back to me
@JovaniDanteGriego
2 жыл бұрын
It's a LSX C10 engine mount
@mud5810
2 жыл бұрын
That is the crossmember. What rubber mount did you use? In your other video your mount is to tall and I am having the same problem.
@JovaniDanteGriego
2 жыл бұрын
Oh just a generic eBay 4l60e rubber mount. It ended up fitting fine. I had the cross member upside down in the first video I think
@yamahondazuki95
Жыл бұрын
Did you make your transmission lines out of AN6 also?
@JovaniDanteGriego
Жыл бұрын
Yes an 6 lines
@yamahondazuki95
Жыл бұрын
@@JovaniDanteGriego I have to check the parts list, did you include the transmission side fittings and cooler/radiator side fittings?
@JovaniDanteGriego
Жыл бұрын
I think so, I'll have to double check. It's been a while
@dwhite4940
3 жыл бұрын
So I’m new to the Chanel I was wondering how much you charge for ls swaps
@JovaniDanteGriego
3 жыл бұрын
I don't do swaps for people
@chestonskenandore433
3 жыл бұрын
Hello I’m doing a ls swap on my 82 c10 , I do have several questions on how to route the fuel line and stand alone harness
@JovaniDanteGriego
3 жыл бұрын
Go for it!
@chestonskenandore433
3 жыл бұрын
@@JovaniDanteGriego will the eBay stand alone harness work? Wat wires do you use from my bulk harness?
@JovaniDanteGriego
3 жыл бұрын
If you buy the ebay standalone harness you get rid of the stock harness, you only need power and ground, and you can adapt your old oil and coolant sensors to the LS block
@mud5810
2 жыл бұрын
what transmission mount did you end up using?
@JovaniDanteGriego
2 жыл бұрын
An eBay one. It's in my parts list in the description
@Ford-tv
3 жыл бұрын
Is it hard to wire the ls to a older truck?
@JovaniDanteGriego
3 жыл бұрын
No if you get a standalone harness all you need is ign 12v and constant 12v
@Ford-tv
3 жыл бұрын
@@JovaniDanteGriego ok cool thanks for the info I might do this to my 75 c10 as well ,maybe a 6.0 or a 5.3
@JovaniDanteGriego
3 жыл бұрын
Use the distributor wire for the switched 12v and the constant will connect to the starter
@Ford-tv
3 жыл бұрын
@@JovaniDanteGriego ok thanks.
@josephescobar5552
Жыл бұрын
Where does the purple wire go for the fuel gauge
@JovaniDanteGriego
Жыл бұрын
You don't use the LS harness. You'll use the original square body wiring and sending unit if it's a stock gauge.
Пікірлер: 32