Got myself my 3rd 3D printer, this time I have switched away from AnyCubic and gone with the Bambu Lab X1-Carbon, complete with an AMS unit (Automatic Material Selection). The AMS unit can hold 4 different filaments, and the printer can have up to 4 AMS units for a total of 16 available filaments.
The printer is 256 x 256 x 256 mm build volume, has Automatic bed levelling and LIDAR layer checking. It also has a camera built in for monitor and automatic timelapse creation.
Having done a couple of test prints so far, it is safe to say this thing is fast! And didn't even have it on its fastest settings....
#bambulab #bambulabx1carbon
----------------------------------------------------------------------------------------------------------
I upload my images to Telescopius, and you can find my profile at:
telescopius.com/profile/dave-...
My other social locations are;
www.daves-astrophotography.com/
/ daves.astrophotography
/ daveauld
/ dave_auld
The main equipment I use is;
Celestron CGX mount
Celestron CGX-L mount
Celestron Edge 11
Celestron RASA 11
Lunt LS80MTB1800C Solar Scope
Bresser 8" Newtonian
Bresser AR90s/500
ZWO ASI2600MC-P Colour cameras
ZWO 60/280 guidescope
ZWO ASI120mm guide camera
ZWO ASI174mini guide camera
ZWO ASI174mm planetary camera
Unihedron Sky Quality Meter (SQM)
NexDome Observatory
#Astrophotography #DavesAstrophotography #Cyprus
Негізгі бет Ғылым және технология New 3D Printer - Number 3! - Bambu Lab X1-Carbon + AMS unt
Пікірлер: 29