Salamat Luqman for sharing. Years ago when Cruzbike Australia sells kit for FWD conversion for $450. It was abandoned by a new Cruzbike company in US for the reason of dangers to others who converts their bikes not intended to. I hope you could design effective FWD conversion in ur country then climb Mt. Kilimanjaro.
@aktux
3 жыл бұрын
Good effort!
@simondr70
3 жыл бұрын
Please put a piece of foam over your microphone next time ..
@teddypunu7814
3 жыл бұрын
The front fork drop out width of a std bike is usually 100 mm, while hub with gear sprocket is 135 mm wide. How did you put the sprocket hub into the drop out of the front fork ?
@binarumah
3 жыл бұрын
Hi Teddy. I widen the front fork from 100mm to 135mm using car jack. what you need to do is to gradually increase and decrease the car jack to bend the front fork. I had to use car jack to open maximum 155mm to get to 135mm wide .This method can only be done to steel fork.
@BayNohut
Жыл бұрын
@@binarumah Thank You!
@IAmMisterD
3 жыл бұрын
Do you have problems steering with this design? I made something similar, then realized it was almost impossible to get my legs to "turn" with the bike.
@binarumah
3 жыл бұрын
Hi. I had no problem for major steering. I just need to see where I want to go then my body adjust accordingly. However for very fine steering on narrow road, I need to tuck both my leg to front boom and steer like normal bike with arm😊
@lucacorso_audiosystem
2 жыл бұрын
kzitem.info/news/bejne/smZttYCinX1ni4Y Forse e più semplice così ..
@zolkapalyibrahim6291
3 жыл бұрын
mana nak beli Cruzbike vandetta kat Malaysia bro ?
Пікірлер: 11