Be sure to use loctite on spider . I diddnt get that step in the video
@Mcgheen2670
11 ай бұрын
Great Video, thanks for the info. How has it held up over the past 10 months? A few buddy’s of mine rebuilt their clutches and had nothing but problems afterwards, didn’t last but another 500-1000 miles. They decided to run the cheap throwaway clutches instead as the cost was the same to rebuild vs buy the new full complete cheap clutch.
@utvgarage
11 ай бұрын
Thanks! Depending on how far gone the clutch is depends how long it will last. I’ve seen a few clutches in excellent shape that only have sloppy rollers. I typically leave it up to the customer on what they want done , but most would rather install an aftermarket clutch vs paying labor cost on a rebuild. If the clutch shows wear in other places I would typically recommend a replacement clutch
@utvgarage
Жыл бұрын
Yea I do 😂
@PDK7777
6 ай бұрын
Will bad rollers ever cause it to make a slight metal sound when under mid load?
@utvgarage
4 ай бұрын
Very possible. I am to the point now were you’re better off throwing the clutch away and replacing it with a new one . I use mother clutcher on almost all replacements . Polaris clutches are disposable in my opinion
@alanivmontano
Жыл бұрын
Sooooo is it possible to remove the pin in the rollers with a hydrolic press??? No one shows the removal process of that pin without beating the hell out of it with a sledge and a punch
@utvgarage
Жыл бұрын
Yes use a small bolt and a socket to press it out
@williamevans3939
Жыл бұрын
you need a camera man!
@jessefields9535
Жыл бұрын
Many other professional sxs mechanics say DO NOT USE brake cleaner on these parts.
Пікірлер: 10