100% agreed. It was good at first, but now it's great.
@cybergnetwork588
7 ай бұрын
Very good review and follow up young man! Straight to the point. Subscribed!
@steve8039
8 ай бұрын
One tip I picked up is to set -0.1mm to the Z offset on the printer settings tab. It seems to help with my first layer issues
@Kosaro1234
8 ай бұрын
If you check out Prusa's tweet on the subject you'll see that they're shipping all new XLs with 0.4 nozzles because it's counterintuitively not any slower than the 0.6: "This change is directly connected with the increased print speed. The volumetric flow (the amount of molten plastic pushed through the nozzle) is similar with both the 0.6mm and 0.4mm nozzles. However, the extruded line is thinner with the 0.4mm version, enabling greater detail but requiring more travel of the print head during the print. With the Input Shaper firmware out, we can now push printing speeds higher (accommodate for increased print head movement) and max out the volumetric flow easily. This means the print times are comparable for both 0.4mm and 0.6mm with 0.4mm providing added fine detail with no downsides. We noticed some members of the community already switched to 0.4mm and seemed very happy!"
@simonschneider5913
8 ай бұрын
high deposition speed often reduces material strength. its not all about speed, thats what injection molding will always excel in
@chrbt6217
7 ай бұрын
With what steel sheet it came?
@dream-bits
3 ай бұрын
Why would anyone buy a Prusa printer when you have Bambulab who makes the best 3D printers on earth for far less the price? 😂
@elchavode6479
8 ай бұрын
Your wrong there no speed difference in speed unless your printing with .32 profile
Пікірлер: 9