Puch Moped Round Bing Carburetor Disassembly & Reassembly 12mm 14mm 15mm
In this video we disassemble and reassemble a 15mm round bing carburetor. This will be the same process for 12mm, 14mm, and 15mm carburetors. These carburetors are commonly found on Puch mopeds.
The parts used in this video can be found at www.dennycycles.com
Part List:
BING TOP CAP BOLT: www.dennycycles.com/bing-top-...
FUEL INLET BANJO GASKET: www.dennycycles.com/fuel-inle...
TOP CAP GASKET: www.dennycycles.com/top-cap-g...
FLOAT PIN: www.dennycycles.com/float-pin...
IDLE SLIDE TOP CLIP: www.dennycycles.com/idle-slid...
RUBBER FLOAT BOWL GASKET: www.dennycycles.com/rubber-fl...
IDLE SCREW: www.dennycycles.com/idle-scre...
IDLE SCREW SPRING: www.dennycycles.com/idle-scre...
SLIDE SPRING: www.dennycycles.com/slide-spr...
CLAMP BOLT: www.dennycycles.com/clamp-bol...
FLOAT NEEDLE: www.dennycycles.com/float-nee...
NEEDLE WITH CLIP: www.dennycycles.com/needle-wi...
CHOKE SLIDE: www.dennycycles.com/choke-sli...
TOP CAP: www.dennycycles.com/top-cap-f...
FLOAT: www.dennycycles.com/float-for...
THROTTLE SLIDE: www.dennycycles.com/throttle-...
FLOAT BOWL: www.dennycycles.com/float-bow...
Негізгі бет Puch Moped Round Bing Carburetor Disassembly & Reassembly 12mm 14mm 15mm Carb Rebuild Repair
Пікірлер