This is an informational video on pump disassembly for the Flygt 2800 pump series. This video is intended as a general reference for technical personnel tasked with maintaining pump performance and ensuring the replacement process is done safely and effectively. This video is NOT intended to serve as a step-by-step, fail-safe checklist. Projects vary and may require additional steps provided for in the Manual not included in this video.
In this video, we will walk you through the disassembly process of the Flygt 2800 series pumps.
For more resources and detailed information about the pumps:
www.xylem.com/...
Contact us here: www.xylem.com/...
Subscribe to our channel for more insights on how our innovative solutions are transforming water and wastewater management.
Disclaimer Warning:
Carefully review the product specific Installation, Operation and Maintenance manual (“Manual”) before tampering with the product in any way.
All user safety rules and instructions contained in the Manual, as well as any other applicable safety rules, must be observed.
This video is provided as general reference only, as a complement to the Manual, and cannot be relied upon as a substitute for professional advice.
Failure to follow all instructions in the Manual may void the manufacturer's warranty.
If there is a question or any uncertainty regarding the intended use or maintenance of the equipment, contact a Xylem representative before proceeding.
Xylem cannot be held responsible for any actions or inactions undertaken as a result hereof.
This video has no sound
00:00-00:34 Introduction
00:34-00:48 Remove the Discharge Connection
00:48-01:47 Mount M12 & Lift Pump
01:47-02:06 Place Pump Horizontally
02:06-02:31 Remove the Strainer & Shock Absorbers
02:31-02:47 Remove the Inspection Plug
02:47-03:15 Remove the Lower & Upper Oil Plug
03:15-03:30 Drain the Pump
03:30-03:56 Re-fit the Plugs
03:56-04:07 Remove the Lifting Handle
04:07-04:47 Fit Eyebolt and Lift Pump Upside Down
04:47-05:12 Untighten & Remove Impeller Screw
05:12-05:31 Loosen the Impeller
05:31-05:43 Remove the Suction Cover
05:43-05:54 Remove the Impeller
05:54-06:16 Remove the Diffuser
06:16-06:50 Remove Oil Housing Bottom
06:50-07:07 Remove the Mechanical Seal
07:07-07:34 Remove the Intermediate Piece
07:34-07:59 Lift Out the Rotor Unit
07:59-08:20 Lift and Turn Pump
08:20-08:39 Remove the Junction Box Cover
08:39-08:59 Remove the Terminal Board
08:59-09:12 Disconnect the Stator
09:12-09:40 Remove the Junction Box
09:40-10:07 Remove the Outer Casing
#Flygt #ServiceVideos
Негізгі бет How to Disassemble Flygt 2800 Series Pumps
Пікірлер