Good video. Thank you. Did you do anything to configure M8 with air? On my m1000 coolant button doesn’t do anything. Any other way to enable tool release besides the ATC button in screenset?
@neofpv6946
Жыл бұрын
How did you do the F1 F2 F3 program? Thanks Eric
@danbirch8939
5 ай бұрын
What codes did you use for f1 f2, and f3? The list only has 1 direction for each code.
@jjba2110
3 жыл бұрын
Thanks - good intro. One question; what codes did you use to program the atc release? Or where did you find them?
@srenskandovneergaard4268
2 жыл бұрын
Hello. I am just looking for the same as you. How do I open and closing manually ?
@mountainmakers
2 жыл бұрын
for the UCR201 Plugin configuration, I assigned 510 (Switches the M8 flood button on, causes chuck to open and release) to the F4 button and 511 (Switches the M8 flood button off, causes chuck to close or engage tool holder) for F5. You can find these function codes in UCCNC Configuration -> I/O Trigger -> INPUT TRIGGER. Just click on any of the Set buttons and the list of function codes is displayed
@jjba2110
2 жыл бұрын
@@mountainmakers Thanks!! I wound up tackling it a different way that was more roundabout. You really simplified it and opened the door for more possibilities. Thanks much!!!
@jjba2110
2 жыл бұрын
@Jairus Martin I don't know why that didn't work for me, so I copied 20206, edited it down a bit and used that. I like your suggestion as I don't like custom code floating around, so I'll give it another go. Thanks Jairus.
@jjba2110
2 жыл бұрын
@Jairus Martin will do!
@jtlatitude
2 жыл бұрын
I like your fixture board. Would you be willing to share your design?
@mountainmakers
Жыл бұрын
I'm still refining it to hopefully share soon, Since then though, I've added a vacuum table
@kayakportugalgear8275
Жыл бұрын
I, can you tell me the codes for the programmable buttos on the top ?
@Flapjack500
Жыл бұрын
X is 220 Y is 221 Z 222
@MrKhalid512
2 жыл бұрын
how to run it in mach4 please tell us how to install it in mach4 step by step and thank you
@mountainmakers
Жыл бұрын
Sorry, this is specifically designed for use with UCCNC as far as I know. You'd have to find drivers for Mach4 if they exist
Пікірлер: 15