hello needs some help. I have a Flysky fs=i10 transmitter, n planning to use on drone xk x380. on channel 6 there is a switch for auto take off n landing and also has another switch for RTH ( return to home) . so how to set the two switch using one channel that is channel 6? Thanks Alex
@RcDude
7 жыл бұрын
you need to assign a channel separately. Thanks
@allabout1135
8 жыл бұрын
Hello! Have question. This is my first RC project, that’s why I am looking for any help. I am building boat with 2 motors. And I am plan to make staring with stopping one of motors. Idea is that .... Is one General Throttle when runs both of motors and boat goes straight, but if to hit other gimbal left or right then stops left or right motor and boat than change direction. So for this plan i need use mixer?
@RcDude
8 жыл бұрын
+Aleksandrs Bebrišs Yes you need mixing plus travel adjustment and hold left joystick on the transmitter and drop travel adjustment to zero. So when you put joystick to the left you left moter power will cut down or make a slower move. Or lower than you right and moter. So that can allow to turn left or right. Note Did you know flying multi roter or qaurdcompter how they work. They work on moters if you want it to work easy and nice you to think about (Multi-Rotor Control Board ) They are very cheap And i am sure that it is going to work nicely you two moter boat. Thanks
@allabout1135
8 жыл бұрын
+Rc Dude Will try to find out how works what you write. I am using Turnigy TGY-i10 so hope that functions what I am looking for will works on my radio :) Thanks for answer !!!
@jawadalhabib2193
9 жыл бұрын
Hello brother how can i do higher rates and low rates for fly warning for DX6i I thank you
@RcDude
9 жыл бұрын
+Jawad Alhabib do you have the new DX6i or old one are you talking about sound setting.thanks
Пікірлер: 7