It turns out rebuilding and refitting a subframe is a little more involved than first thought! Firstly an apology as this video took waaay longer than I'd planned but hopefully enough is covered to give anyone having a go at this sort of work a bit of insight. Secondly, another apology, when filming I'm often referring to nuts and bolts as though they're the same thing sometimes!! 🤔...I'd like to think I know the difference by now...it tends to be where I've had several attempts at filming the same job and got a bit flabbergasted!! 🤣😂
It feels like there's light at the end of tunnel now, just a few jobs required before turning the key and then MOT time!!! or.....perhaps several more jobs if the engine work isn't up to scratch!!!! Fingers crossed!!! 😳😱😢😲
~~ Products I use during this video ~~
machine tap set --- amzn.to/3st8qTb
3/8-inch Extension Bar Set --- amzn.to/3bOd5ZY
1/2-inch Breaker Bar --- amzn.to/3ilAjHT
Milwaukee M12 Impact Wrench --- amzn.to/3sxdhm1
=== Social ===
Instagram: / _mg_lee_
Facebook: / mglee453
Twitter: / mg_lee_
Негізгі бет Refitting a subframe on the MG TF
Пікірлер: 70