Any time I ever had to replace a ball wheel belt, I would NEVER cut the old belt but rather would leave the belt intact so that I know what I need to remove and would work the old belt as I progressed toward removal of the damaged belt. NEVER cut that belt unless you are well-skilled in changing ball wheel belts!
@jordanschmidt1144
2 жыл бұрын
Thanks guys my wife and a just Bought a bowling alley and I was so luckily gifted the mechanic job thanks again fellas great video
@spaceninja1252
8 жыл бұрын
thank you so much for this, helped immensely. had one break tonight during league.
@skibbiethegamecat9057
Жыл бұрын
Great video, easy to follow and accurate. It took me three hours to do what you did in twenty minutes, but I got it done thanks to this.
@elijahstrassell8432
6 ай бұрын
Same. This stuff is not as easy as it looks for sure
@toddedenstrom1466
Жыл бұрын
Took your class you ROCK !!!!!!!!!
@jordanschmidt1144
2 жыл бұрын
Awesome video fellas my wife and I just bought a Bowling Ally and it was very informational and very helpful
@wrenchinonthose70s
11 жыл бұрын
Wow I wish my back end was that clean. Great video!
@tonychastain7710
Жыл бұрын
Right?! I couldn't even imagine what have an isle like that is like
@blackbeard6663
7 ай бұрын
We just use ez clips. Take new belt cut it run it through like you took the old cut belt off. Then ones its snaked back through. You take your vice scripts clamp the clamp in place then take the other clamp side and connect to to other side of belt. Clamp that down and your done. Takes about 5 minutes and no need to take any thing apart or other belts off.
@raymondmunoz6118
3 жыл бұрын
That's like the long way to change that belt
@20alphabet
2 жыл бұрын
New subscriber
@JohnSebeny
10 жыл бұрын
MORE MORE MORE! That was insane. Takes me about 45min, but I undo a heck of a lot more stuff. Going to have to remember this. Thank you for the video masternut.
@dirtyernie65
Жыл бұрын
A-2s ? And no tubes on the ball lifts?
@kirkthejerkthe1st
2 жыл бұрын
What? No ball lift rod covers?
@laurencehall7920
2 жыл бұрын
Question you said around the 1 minute 20 second mark that you have a modification kit on your belts what is that kit and what does it do
@RockOn829
Жыл бұрын
No lift rod covers ? What are the chains for ?
@robertmiller9207
4 ай бұрын
Where's the lift rod covers....????
@redneckman335
3 жыл бұрын
Is that a regular ball wheel tensioning spring hooked into the catwalk
@kevincoleman5334
3 жыл бұрын
Make more videos
@thomasnutt2488
Жыл бұрын
You put a new belt without taking the j bolts out
@duanewest4493
3 жыл бұрын
Removing the J-bolts will save you about 2 minutes. You don't have to remove the cross conveyer belts.
@saltesta2562
3 жыл бұрын
Clean machines. I love the Japanese pinsetters. You did not have to pull cross conveyor belts though.
@kevincoleman5334
3 жыл бұрын
Link belts are much more easier and time saving and last longer
Пікірлер: 24