In my case with the older Opel zafira was connectivity problem by the ECM , because pedal had separate power to both pedal position signals, and one of them has bad connection with the ECM, in case sometimes missing one of the signals.
@thomasmacthomas3059
6 ай бұрын
Wow nice work I have a problem on my opelastra h z16ex1 I overall my engine and now there’s no spark it crank sometimes
@richardkennedy7941
2 жыл бұрын
My Astra 1.7 cdti sxi cut out driving along the other day like it ran out of petrol, wouldn't start for 5 mins then fired up drove about 50 yards then done the same got it started after about another 10 mins trying then it fired up got about 100 to 150 yards then cut out again eventually got it started and pulled into MacDonald's to get recovered tomorrow, apparently some wire or something on the ECU burns out, need to find out how much it is to replace the ECU or can you just change the chip
@sarahlou75
Жыл бұрын
Hi, I have a 2003 Fully Automatic Astra Elegance, its throwing up the codes P1700 and U2106 and starting off in 2nd gear. My garage have sent the ECU off to ECU testing who having now received the unit say that they cannot test or repair it. I wondered if you could help? I have no idea what to do for the best now to get the car back on the road. Thanks Sarah
@claudiomargiotta4606
Жыл бұрын
Hi, I did an ecu reset on my Meriva A 1.6 because I always had errors on the carburetion (despite having replaced the lambda probe and manifold pressure probe). After the reset I had to reprogram the immobilizer. From after the first ignition the engine runs at 3 (cylinder 2 misfire error) will it be a coincidence that I have melted the coil?
@ImNotADeeJay
2 жыл бұрын
good morning, great video. My corsa (2007 1.4) started having a/c issues (it would stop cooling randomly), then I noticed the cooling fan started to act, and eventually, the engine management light came on. I took the car to the shop, they say me there is a problem with the ECU and they have to send it to a specialized company to refurbish it. 400 quid. What do you think, does it sound legit to you? Thanks.
@hitmen2025
2 жыл бұрын
Ho my8 good job i have a opel corsa c 1.7 2001 ecu like 4 pins are broken car don’t pull eight as turbo don’t get active if i just buy a new ecu just the ecu plug it in and have some one programmed well it work how do you get that software cheers from albania
@marcosaureliocamposgomes7763
Жыл бұрын
I have an Astra 2007 1.8 I had some lights on on the dashboard I put a fuse where it was without the car stopped working, start it normally and it doesn't turn on the car they are condemning the central reprogramming it can go back to normal
@harveydann7015
4 күн бұрын
Hi mate. Where is the ecu located please?
@gamechanger9157
2 жыл бұрын
Great Video Pal, very informative and clear instructions. However, i seem to have run into trouble if you can throw some light please- I did Reset the Old ECU using security code, swapped with a replacement one that came along with a PIN (or security code). Went to program the new one but security code of replacement ECU wont accept. I tried the original security code from first ECU, didnt accept. Now cant program the replacement ECU. Any help is really appreciated please .
@Luke-hc6ud
Жыл бұрын
For those of you with the same question: When swapping ECU's you do not need to reset your old one unless you plan on selling it. If you have bought an ECU that has already been reset, all you need to do is reprogram it using the pin for your car. (Not the one that came with the replacement ECU). From my understanding attempting to re-program an ECU to your car using anything but the code for your car will lock the ECU.
@sama.m882
2 жыл бұрын
I have a damaged ecu, and couldn’t reset it, i would like to ask. If i buy a used one same code letters (BB) for same car( astra h gtc 1.4) should be the used ecu reset? Will it work using Op-com? And should i have the security code from the new ecu?
@zedalon
2 жыл бұрын
Your best bet is to either buy one has been reset while still in the donnor car,then you should be able to program it with op-com. And it would be good idea to get the exact same part number. Also if you can communicate with the old one take a note of all the changeable settings so you can set the new one up correctly
@andrewnelson4368
2 жыл бұрын
Where do you get the security code from?
@zohearhirji1643
2 жыл бұрын
HI mate, I have a Corsa D 2013 semi-auto which has come in with a used Transmission control Module fitted on it, however I do not have the old unit or the details of the car that the unit on the car is from. Do you know if there Is any way to program it to the vehicle? Thanks
@zedalon
2 жыл бұрын
I don't think you can problem it without the donner car pass. Best solution would be swap modules with the one from the original gearbox
@zohearhirji1643
2 жыл бұрын
@@zedalon I don't have it unfortunately as we got the vehicle as it is the original gearbox unit has been thrown away by the previous owner. I'm just trying to find the best workaround to get the car working again.
@zedalon
2 жыл бұрын
You will need to get either a module with its pass or one that's been deprogrammed already
@imranfire6
5 ай бұрын
Hi mate, I have an Astra H VXR & I have troubles with my key signal & it won't start sometimes. I've been told I may need to replace my ECU. I would pay you whatever it takes to fix this ongoing problem. PLEASE can you help me? Thanks
@mgamingmgaming3460
3 ай бұрын
Great video, I have a astra h 1.8 automatic ECU is not comunicate at all, need to be programmed again, where I can find a file with the program ?
@zedalon
3 ай бұрын
Hi,do you mean Op-com program?
@DSN262
3 жыл бұрын
Anyone's abs light stayed on permanently?
@deindjis
Жыл бұрын
Can i replace ECU (switch the new one without reset it before that and reset it to the "new car")
@zedalon
Жыл бұрын
I theory if you have the car pass from the Donner car you should be able to reset it in you car,but I have not tried it my self so not 100% if it will work.
@fletchc187
2 жыл бұрын
What software is that mate
@zedalon
2 жыл бұрын
It's OP-COM
@jasoncarthew2279
Жыл бұрын
What software do you use
@zedalon
Жыл бұрын
Op-com
@A1topmechanic
6 ай бұрын
Why do u need to deprogram or reset the damage ecu? When u r going to replace it anyway for another one
@zedalon
6 ай бұрын
I wasn't 100% sure if I need to but thought best to air on the side of caution,as not sure if just programming new what remove the old one data from the system
@dimgre74
2 жыл бұрын
where did you find the immo code .?
@zedalon
2 жыл бұрын
It's on the car pass/security info card in the owners handbook folder
@conradwallace3404
2 жыл бұрын
@@zedalon do you know where to find this if I don’t have this folder?
@zedalon
2 жыл бұрын
If you can't find the car pass security card in your glove box or handbook folder then you can go to your local vauxhall/Opel dealer for about £30 I believe they will give you the passcode for your vehicle.
@turbo2092
2 жыл бұрын
Where is the ECU located..?
@zedalon
2 жыл бұрын
It depends on which engine you have mine was on the right hand side of the head. I know some other engines have it right on top of the engine.
@turbo2092
2 жыл бұрын
@@zedalon it's the z14exp, so definitely not on top of the engine. I've tried searching online all day so I don't take off the wrong fender/the front bumper. Do you know for sure where it would be for this engine?
@zedalon
2 жыл бұрын
That the same engine I have
@turbo2092
2 жыл бұрын
@@zedalon It's an opel astra in Germany, you're in the UK right? So not sure it's the same, but hoping so. Could I bother you to send a picture of where your's is?
@zedalon
2 жыл бұрын
If I can figure out how to share photos on here lol
Пікірлер: 42