I bought the same miter gauge and have the same issue. Being able to 0 the miter gauge is very important. The preset indexing slots are absolutely worthless, in my opinion. Your indexing tool is very slick. I don't think you should have to buy that tool to check a " upgraded " miter gauge. I just emailed Rockler to see if they will do something for me. Hopefully, they stand behind their products. Thanks for posting, I've come across several comments all stating the same issue.
@johngalvin1653
3 жыл бұрын
Thank you.
@rockinjuliescott
Жыл бұрын
Good video. Thank you!
@path9mm
3 жыл бұрын
Great job reviewing the miter gauge. One thing I'd like to know is what was the reading on the miter gauge after you adjusted it with the Miter Set? If you had it precisely at 22.5 degrees before using the Miter Set, then what was it reading after? I would just like to know how much it was off. I wonder if you can calibrate the miter gauge via some adjustment, perhaps even the plastic site window is just off.
@Spratlyk9
3 жыл бұрын
I did not take note of the reading. I also did not calibrate or make any adjustment on the miter gauge, i just used it right out of the box. It is a good and well built miter gauge, and with some adjustment, it could probably be as precise as the Miter Set Segment.
@TheBandit5001
3 жыл бұрын
Can you post a link to where you got the miter segment tool?
@Spratlyk9
3 жыл бұрын
miterset.myshopify.com/collections/all here is the link
@stevesiefken6432
3 жыл бұрын
Did you have any problem with this miter gauge scratching the surface of your table saw?
@Spratlyk9
3 жыл бұрын
Yes, but i put an adhesive thin plastic sheet underneath and it solves the problem.
@stevesiefken6432
3 жыл бұрын
Do you still like the miter gauge? I am thinking about buying this one. Thanks! BTW, I have the same table saw.
@Spratlyk9
3 жыл бұрын
Oh yes, I like it so much and I often use it. I would buy it again if necessary.
@stevesiefken6432
3 жыл бұрын
@@Spratlyk9 How accurate is it? Do you have to use the miter set up block to ensure the miter gauge angle accuracy or can you rely upon the settings of the miter gauge itself?
@Spratlyk9
3 жыл бұрын
@@stevesiefken6432 I can rely on it in most of my work. Only in making multiple difficult angles do i used the Miter Set Segment (like Octagon, Hexagon, etc...)
Пікірлер: 13