I don't understand a word, but I understand the feelings. Thank you for the upload, it's a fantastic machine!
@TheHardStyleLife
Жыл бұрын
Yes^^
@CounterStriker013009
9 ай бұрын
Is about the RX700 information
@casefc3s
Жыл бұрын
man, for a 12-year-old upload, whoever recorded/put this up had a darn good setup. had a good laugh as a long-term rotary enthusiast with the time it took to get started. :)
The tail lights look like they are from a theme park ride from Disneyland
@jeffmullinix7916
Жыл бұрын
They went out and found a old Sach chainsaw rotary engine and stuck in there . The car was made of pressed cardboard . The same pross as old Russian cars . They also found the wheels and drive line from a Pontiac Fiero for 800 bucks . I thought it made in China not built in Japan . Big big difference . Japan I hate to say top Quality to a degree . In China they just dont give a rats ass The parts just sucks on most things . I took a look at some RC aircraft electronic boards on a RC Transmitter the other day . All the solder joints was corroded and a lot of bad bad solder joints I had to clean up , It took men 2 days to clean up the mess and trade some components because they was junk . Even thought the Transmitter worked before but would not worked in the long run . I remember these RC transmitter and receivers was made in Japan and they was top quality . The boards the solder joints and components . These transmitters and receivers was made by JR , Futaba , Airtronics . They was great . Not not so much .
Пікірлер: 308