Hot damn.....!!! Beauty to look at and a pleasure to hear...! What a sound...!
@MattBlank0
Жыл бұрын
That is a beautiful thing
@serkansalah1883
5 жыл бұрын
Hello Morris' Mini Motors I have a saito FA325 and have a question if you please to answer : When i try to install some propellors 2-blade like masterscrew classic or 3-blade, like biela 3 blade for a FW190 project, i come up against a problem : spinners backplate+propellor+first nut fits but no space left for second nut/the locking nut. Main shaft is kind of short. Can you advice me a solution for this ? I was thinking about using a self locking nut, you know these nuts with silicone or nylon ring inside... I would be so pleased if you can reply, Best Regards, Serkan Salah
@173shatta
5 жыл бұрын
serkan salah What you will need is a sleeve nut to go inside to the prop
@serkansalah1883
5 жыл бұрын
Thanks for your reply, so if i understand correctly, i need to enlarge the propellor center hole a bit, use a sleeve nut that goes inside the propellor center and than use a second nut as locking nut, correct ? Please forgive my lack of knowledge :) this is the first time i face this issue...
@andrej1509
5 жыл бұрын
this is 53cc?
@sandscorcher3332
4 жыл бұрын
22x8 at 5000 RPM are bad numbers for this engine. Use the Static Thrust Calculator and you read about 1.64 hp!
Пікірлер: 8