This is a long one, Sorry, but it pretty much goes through the step by step and shows some of my mistakes so you don't make them.
Also, verify that the gasket fits. If you have the time then I would suggest bringing the valve cover in with you(assuming you bought it from a local parts store) and make sure it fits before leaving. I must have gotten one from a bad batch because the first one was too big. You will see that in the video. The second try was the right(ish) one. apparently it is a known problem that the molding process is incorrect for these gaskets but luckily they are rubber so you can just remold it to fit.
Also a word of caution: at some point you may see me use carburetor cleaner on the plastic valve cover. DO NOT use carburetor cleaner on the plastic. The main ingredient is Acetone(which I also use to clean) and it has the ability to melt the plastic. Use another solvent that is friendly to plastics like mineral spirits.
Good Luck and Hope this helps you save some money. Spent about $60 total doing this in tools and parts.
------------------------------------
Like my content? Donate to the cause!
Paypal: paypal.me/Jung...
Coinbase: @JungleKing007
------------------------------------
Note: I am not a mechanic, these videos are meant to be for informational purposes only. Should you follow the steps shown you do so at your own risk.
Негізгі бет Автокөліктер мен көлік құралдары Saturn SL2 Valve Cover Gasket Replacement (DOHC)
Пікірлер: 167