In this video I go over Section 1.8 of Luke's Guide, Esteps and Flow Rate. I have updated the Math in the examples below. Luke now uses a .8 wall on the test cube as it's more accurate.
🛑Subscribe for more: www.KZitem.com/theedgeoftech...
🐱🏍Share this video with a friend:
• Section 1.8 ESteps and...
💾 Share this channel with a friend:
/ @theedgeoftech
EStep Calculation:
100 (commanded Steps) divided by 98 (actual steps taken) = 1.02
1.02 x 93 (Current ESteps) = 94.86
95. is your new ESteps if you round up
Flow Rate Calculation:
Value of all 8 measurements divided by 8 = Average Measurement.
.80 divided by average measurement multiplied by 100 = New Flow Rate.
Example:
.78+.80+.76+.79.+.80+.81+.75+.78 - 6.27 Equals Total Walls Measured
6.27/8=.783 - Total Walls Measured divided by 8 (8=total measurements taken, 2 on each side of the cube)
.8/.783 = 1.02 - Wall thickness (.8) divided by Average of Total Walls Measured (.783)
1.02x100=102. = 102 is the new flow rate.
Luke's Short throw Calibration Test Cube: www.thingiverse.com/thing:322...
Luke's Help Guide
support.th3dstudio.com/hc/en-...
Disclaimer: Some of these links go to one of my websites and some are affiliate links where I'll earn a small commission if you make a purchase at no additional cost to you. As an Amazon Associate I earn from qualifying purchases.
Ender 3 V2 Amazon: amzn.to/2OA9bug
Code: 07ZGQI2J to save some money!
Ender 3 V2 Amazon:amzn.to/3qRzLwb
Code: 07GZXYYD to save some money!
Decent Caliper for 3D Printing: amzn.to/3elcw8N
Ender 3 Pro on Amazon: amzn.to/3ak9BtS
Ender 3 direct from Creality:
Ender 3: www.creality3dofficial.com/co...
Ender 3 Pro: www.creality3dofficial.com/co...
The Edge of Tech Amazon Affiliate Store Front: www.amazon.com/shop/theedgeof...
Support the channel through these links!
PayPal
paypal.me/theedgeoftech
Patreon
/ theedgeoftech
Watch next - Luke Hatfields Help Guide Playlist - • Luke Hatfield's Help G...
Recommended Playlist - Community Showcase - • Community Showcase
Let’s connect:
Instagram: / theedgeoftech
Twitter: / theedgeofteck
Facebook: facebook.com/TheEdgeofTechOfficial
----------------------------------------Credits-----------------------------------------------------------
Music by Wicked Realm
Album - No More Fairy Tales
Song - Feed
/ @wickedrealm5507
Негізгі бет Ғылым және технология Section 1.8 ESteps and Flow Rate
Пікірлер: 744