What part number for the springs you used in your msd distributor
@carsntrucks782
Жыл бұрын
kzitem.info/news/bejne/2aucv4edrJucfJw
@LJC5865
Жыл бұрын
How do you adjust for total timing when it's way off..springs or an Allen wrench at the vac canister.
@heavychevy2289
Жыл бұрын
Rev it up to 2500-3000 rpm with the vacuum advance disconnected from the carburetor. Counter clockwise will advance the timing clockwise will retard the timing. I'm assuming you do have a sbc or big block
@carsntrucks782
Жыл бұрын
Disconnect the vacuum canister. The total timing advance happens at different rpm’s. Depending on how your distributor is curved. Could be 2,000 rpm or 3,500 rpm I keep reviving higher until it won’t advance any more.
@road2richz_q266
Жыл бұрын
@@heavychevy2289 Hey I have a 4 barrel edelbrock carburetor 600cfm with electric choke mounted on a 350 sbc engine, I just got it to fire for the first time since rebuild 2yrs ago, I have a high idle a 3,000rpm, I've adjusted the mixture screws and idle is still not going down, could it be that I have my distributor too far advanced?
@carsntrucks782
Жыл бұрын
@@road2richz_q266 Yes it can cause, you to idle high. But so can a vacuum leak. I’d check the idle and fast idle screws first.
@road2richz_q266
Жыл бұрын
@@carsntrucks782 I fixed it turns out it was just my throttle bracket not closing all the way back, I had to readjust my spring it didn't have enough tension on it
@SSScottSS
Жыл бұрын
This is completely wrong on how to set your timing. DO NOT FOLLOW THESE DIRECTIONS. Original poster should take this down asap.
@kylel5p454
9 ай бұрын
When you set the gun at 34. Where is it showing on the engine.
@carsntrucks782
9 ай бұрын
The line on the harmonic. Balancer and the time tab on. The engine are aligned
@kylel5p454
9 ай бұрын
@@carsntrucks782 I get that but what degrees should it be around
@carsntrucks782
9 ай бұрын
@@kylel5p454 it depends on your engine compression. Are you running nitrous or forced induction? then you would have Timing set at a lower degree for a pretty stock SBC around 34° will be good
@kylel5p454
9 ай бұрын
Sbc 350 carb. Has a cam. And msd ignition.
@carsntrucks782
9 ай бұрын
@@kylel5p454 I’d start at 32 degrees and test. Drive make. Sure there’s no detonation and keep adding I’d guess around 34. Degrees would be pretty good.
Пікірлер: 21