awesome video, one question though, should we leave the old grease that was there before, or should we clean it and replace with new? thanks.
@victortihonov4093
9 жыл бұрын
You should wipe out the old grease ! If you like to purchase this stretchable cv boot you can do it from www.viagra4cars.com in cv-boot section ! Or by calling: 1 888 558 2668 !
@mylittlepony4660
7 жыл бұрын
where can I get this boots opener?
@bossman6290
6 жыл бұрын
my little pony its not cheap but plastic ones available
@bEEBO178
4 жыл бұрын
@@bossman6290 or just do it the proper way and remove the cv joint which takes 20 seconds unlike this trash.
@TomKaosOfficial
6 жыл бұрын
At this point, who the fuck needs a expensive ass tool, just knock the joint off and complete the job.
@alan22216638
5 жыл бұрын
This was made in Taiwan!
@mickcarson8504
6 жыл бұрын
And this tool is... made in China?
@mickcarson8504
6 жыл бұрын
Tour of Rooms I am fed up with this Made in China consumer products. Everything that is made in China doesnt last long. In clothes, they rip, fail, fade, collar doesn't remain firm after a few washes, lint that make a mess in the washing machine, cheap fabric that rips at their seams. The list of fabric products that are of shit quality is endless or limited to your own experiments. The same with all other products that are made in China, including electrical, electronics, machinery and components made for those machinery, textiles, electrical tool of all sorts, including sockets, drill bits, hobby tools, toys and models, in fact the list of junk being shipped everywhere from China is also a catastrophic problems for the environment as thousands of container ships travel back and forth to deliver the massive amount of junk, yes junk that could have been produced to a lesser extent had it been made at Home where the people would have bought products made at Home without the need of naval transportation that is causing global warming and pollution, not to mention an occasional ship full of containers, loaded with junk or not, sinking in rough sea storm and littering the ocean floor. In a span of 50 years from now, I'd like to see the ocean floor along the shipping lines littered with sunken ships and containers sprawled all over them. This tool falls exactly into that category. A tool like any other tools that should be made in the country where it is needed and used, and not imported from another country by ships because long distances means more environmental damage to this sensitive planet. If Americans want a tool of this type, it should be made in America for American motoring industry. Not only that it will be made better, stronger and safer than the Chinese made shit but it also creates Home jobs and will be a trusted brand by the Americans and, the thing that is no longer done is the use of ships to transport Home made products and therefore there would be less ocean graveyards of sunken ships and (if you want me to wake you up a little further) the fish you eat would be cleaner and less contaminated. The least we say, it's good to enjoy our technology without destroying the planet and all life and food chains with it. I see no reasons whatsoever why all companies that used to produce products in their own country have eloped to China, produce their products there al cheapo and then ship the junk back to you and sell at the standard price set in your country. Why do bastard Governments allow this to happen and keep millions of workers unemployed everywhere in their countries and keep China wealthy. Why is this happening. America had everything for their own people, why they allowed companies to leave for China, produce there and then allow their products to be sold back to Americans and other countries, such as Australia, N Zealand, S Africa, UK, etc? Take it from me, it's a world gone absolutely mad in my opinion.
Пікірлер: 10