Nice video Mike! Greatly appreciated! I recommend that you consider filming the machining and then do a voice-over later so that your voice can be clearly heard. Nice!
@garytuttle1691
4 жыл бұрын
Good work for sure, couldn't hear a work, though it needs a lot more volume on the voice
@manyglacier1980
4 жыл бұрын
Someone may have asked this already, but I'm wondering if you've found the lathe features of the Smithy to be adequate (threading, basic turning operations)?
@desmes62
9 жыл бұрын
Very pleasant to watch now that you deleted the camera vibration;)
@airgunningyup
7 жыл бұрын
it must take a long time to switch from the lathe to the mill? because you would have to square up the vice every time? ive never run a dual machine
@abcanimal
7 жыл бұрын
Just a quick suggestion. You should blow away the metal chips as your milling.
Пікірлер: 6