Regarding Projecta 7 stage Intelli Chargers. I just learned they use a voltage sensing wire within the charge cable. So fitting an anderson plug will need extra care. What is the best way to modify the charge cables to fit the Anderson Plug ?
@GriselDeArmas-Burke
14 күн бұрын
I’m just getting the AGM slowly flashing blue with no charging indicator. Plugged into power. Unplugged it then still flashes blue.
@DaveUtz
Жыл бұрын
gday have had issue with idc25 in my ute not getting g any charge output side with open circuit lights had tech come look and verified i had good earth so I have removed unit now after over 12 months not getting it to work . but question is can I use unit to run solar in my caravan
@thecrowsblow
Жыл бұрын
Perfect. Thanks for the video. It helped me fix a bad earth problem.👍😊👍
@sionetauhopohopoofamooni8380
Жыл бұрын
How do I get the switches to work my dual battery died but projecta didn’t notify me
@KarenFewked
27 күн бұрын
have just relaced my projecta ic25 charger and the lights keep flashing
@mattsinclair6954
2 жыл бұрын
Gday, I just finished installing my IDC25 with alternator and 240w solar input. My start battery is conventional lead acid and house battery is AGM. When I checked my voltages today, both batteries were close to 16v. Is there a technical support number I can call in NZ please? Thanks
@ProjectaAustralia
2 жыл бұрын
Hi Matt, you can contact us on 0800 294 294, Cheers DA
@bushyfromoz8834
11 ай бұрын
why did the ICD25 not have a lithium profile in it?
@KarenFewked
27 күн бұрын
just replaced my projecta ic25 charger and lights keep flashing
@Graciela.Feb28th
2 жыл бұрын
Hey there! Thanks for the great info. Since yesterday my solar panel stopped charging my battery for the first time in 6 months. Terminals are clean and I can charge the deep cell battery with my intelligent charger with a geni without problems. The box is working great after I ran the learning cycle on full but sadly my solar isn't charging it. Went up and the panel looks good and clean. Could it be anything else? Thanks again!
@ProjectaAustralia
2 жыл бұрын
Hi Graciela, this unit wont stop the battery being charged, if the battery is not charging then there will be something wrong with your panel regulator. Cheers
@Graciela.Feb28th
2 жыл бұрын
@@ProjectaAustralia Thanks for the reply. I have another box and new solar panel atm, replacing and checking it as an extra help becuse it didn't work and it gave me too many problems. I will keep it as a back-up. Thanks
@chironex785
2 жыл бұрын
Hi my charger is showing a flashing red light on the solar indicator and the secondary battery is not getting a charge. I guess it’s an over voltage issue but it doesn’t clear when the solar cell is disconnected. Any clues?
@ProjectaAustralia
2 жыл бұрын
hi Daryl, please remove the DC-DC chargers earth cable and reconnect.
@chironex785
2 жыл бұрын
@@ProjectaAustralia sorted thanks
@bazdervo6815
2 жыл бұрын
Gday mate I noticed on my volt monitor it was pretty low bouncing around 9.5 and 10.5 v ,I’ve got a solar panel connected to my power box and alternator plus solar lights on my charger were both green the charging light was flashing green along with the blue battery selector light in this case agm,any ideas at to why I would be dropping off in voltage? Cheers mate, baz
@ProjectaAustralia
2 жыл бұрын
hi Baz, 9.5 volts is very low for a battery the unit does control the voltage in any way so if the voltage isn't coming up it is ether the battery or the charger. Cheers
@bazdervo6815
2 жыл бұрын
@@ProjectaAustralia ok cool thanks for getting back to me I've been keeping an eye on it it's been bouncing between 12.6 and 10.1 .cheers mate baz
@mfreiher
2 жыл бұрын
Hi, I have a ip1000 and the output voltage is 285 volts. Is there a way to reduce it to 230 or 240 volts?
@ProjectaAustralia
2 жыл бұрын
hi Mate, are you testing the voltage under load? as an inverter will not be the correct voltage until amps are flowing.
@mfreiher
2 жыл бұрын
@@ProjectaAustralia no, but it's burning out my appliance. My other inverter is 238 to 240v no load.
@vickieoz
2 жыл бұрын
my IDC25 is flashing alternator only when the vehicle is parked and should be on solar
@johnbrydon1287
2 жыл бұрын
what does it mean if blue led agm light is flashing
@ProjectaAustralia
2 жыл бұрын
hi John, it does depend on if the green light is also flashing or solid, if the green light is flashing it is in Absorption, if the green light is solid it is in Equalization. Cheers
Пікірлер: 25